Fein M55 User Manual - page 10
10
9 01 04 007 01 0
en
Inserting the screw strip (5).
➤
Push the screw strip (5) through the
screw strip guide (b).
➤
Guide the screw strip (5) over the
tooth points of the notched discs on
the sliding piece.
➤
Push the screw strip (5) forwards. The
first screw must be positioned in a
groove in front of the centre point of
the screw stop (4).
➤
To remove the screw strip (5) pull it
out upwards.
Setting the magazine holder to the
length of the screw (4).
The magazine holder must be set to the
respective length of the screw.
➤
Turn the grooved knob on the screw
stop until the point of the screw and
inner edge of the screw stop are flush.
Please observe the measuring scale on
the screw stop.
Setting the screwdriving depth (3).
The required screwdriving
depth can be obtained by
adjusting the grooved knob (3).
Upwards adjustment:
If the screwdriving depth is greater, the
screw head sinks further into the work
piece.
Downwards adjustment:
If the screwdriving depth is less deep, the
screw head will not sink as far into the
work piece.
The required screwdriving depth will
depend on the material to be treated and
is obtained by trial and error.
Operating instructions.
Before screwdriving work check the
direction of rotation of the drive
machine. The magazine holder may only
be operated in the position “Clockwise
rotation”.
Always hold the drive machine at
right angles to the work piece.
➤
Switch the drive machine on, lock the
ON/OFF-switch and position the
screw stop (4) on the position to be
fixed.
➤
Using an even pressure, press against
the surface of the work piece until the
screw is inserted. The next screw is
automatically brought into its working
position.
➤
Lift the drive machine from the work
piece.
Any screws that have already been
inserted cannot be taken out again or
tightened using the magazine holder.
Cleaning and care.
Risk of injury
by switching the tool ON unintentionally.
Before cleaning, pull out the mains plug.
Weekly cleaning (6).
➤
Removing the screw strip.
➤
Press the release knob (2). At the same
time, hold the sliding piece (c) tightly
so that the spring does not press it out.
!
3 41 01 083 06 0.book Seite 10 Dienstag, 26. Februar 2008 3:02 15