Fein M55 User Manual - page 11

9 01 04 007 01 0

11

en

➤

Remove sliding piece (c), actuation 

bar (d), compression spring (e) and 

spring guide (f) from the magazine 

housing. Take off the magazine hous-

ing. Blow out all parts with compressed 

air. Remove major debris, e.g., with a 

cloth. Especially clean the recess (d1) in 

the actuation bar (d), as this could lead 

to malfunctions of the magazine. Do 

not use water for the cleaning; do not 

apply oil or lubricate.

Assembling the disassembled magazine 

holder

➤

Slide the dismounted and cleaned mag-

azine housing over the screwdriver bit 

and place onto the spindle collar of the 

driving tool to the stop.

➤

Press the roll (g) outwards and position 

the switching strip (d) into the guide in 

the middle between the stop and the 

roll (g).

➤

Place the pressure spring (e) into the 

sliding piece.

➤

Insert the spring guide (f) into the pres-

sure spring (e) as shown in the figure.

➤

Insert the complete assembled compo-

nents in the magazine housing and hold 

tightly.

➤

Press back the switching strip (d) on 

the outside as far as the stop until it 

notches automatically in the magazine 

housing. If necessary, press the release 

knob (2) to notch the switching 

strip (d).

➤

After the switching strip (d) has 

notched in the magazine housing, let go 

of the sliding piece (c) again.

Maintenance and repairs.

Risk of injury

Service, testing and repairs may only be car-

ried out by electrical engineers in conformity 

with the regulations valid in the respective 

country.

Maintenance and repairs.

For repairs, we recommend our FEIN cus-

tomer service centre, the FEIN authorised 

service centres and FEIN agencies.

When carrying out your own repairs by 

qualified electricians we supply the repair 

documentation upon request.

Repairs may only be carried out by quali-

fied electricians in conformity with the 

valid regulations.

Please always hand this Instruction Manual 

to the those carrying out the repair.

Accessories.

Only use accessories recommended by 

FEIN.

Warranty and liability.

The warranty for the product is valid in 

accordance with the legal regulations in 

the country where it is marketed.

In addition, FEIN also provides a guarantee 

in accordance with the FEIN manufac-

turer’s guarantee. For further details on 

this, please contact your specialist dealer, 

your national FEIN representative, or the 

FEIN customer service centre.

!

3 41 01 083 06 0.book  Seite 11  Dienstag, 26. Februar 2008  3:02 15