Feller CM 200 User Manual - Brewing
8
Brewing
1. Put 1 cup or 2 cups on the main
body (9) properly according to
the mass of water that you have
filled into the water reservoir (1).
(SEE FIG. 4).
2. Plug the unit into outlet.
3. Set the power switch (7) to “1”
position and the pilot lamp (6)
will be on, indicating that the
water is being heated.
4. After the pilot lamp (6) is off, set
the power switch (7) to “0”
position, then remove cup (5) from the coffee maker carefully.
CAUTION: TO AVOID A DAMAGE OF THE SCALE BY THE STEAM, DO NOT TAKE
THE COFFEE BOX (4) OUT OF THE COFFEE MAKER IMMEDIATELY AFTER THE
PILOT LAMP (6) IS OFF (WAITTING FOR 2 MINUTES IS RECOMMENDED).
STORAGE
1. Set the power switch (7) to “0” position and unplug the unit.
2. After the coffee maker is completely cooled down, remove the coffee box and
cups from the coffee maker and pull the water out of the water reservoir. Then
clean the main body (9) with soft cloth and wash the cups, coffee box and filter
basket with warm cleanser water.
Caution: Do not immerse main body (9) in any liquid for cleaning.
3. After the coffee maker is dried, assemble them properly; then put the unit into box.
Store it in a dry place beyond children.
IFICATION
ELECTRICAL SPEC
Rated voltage
Rated power
AC 220V-240V 50Hz
350W
Insulation class: Electrical appliance class
Q
FIG.3
FIG.2