Fellowes jupiter a3 Instructions Manual - English
4
ENGLISH
HOT LAMINATION STEPS
1. Please connect the laminator to the
socket using the separate power cable
supplied.
2. Switch laminator on with Power On /
Off button at back of machine.
3. Press Stand-by button at left of front
operating panel to switch laminator on.
4. Use navigation keys to select setting for
the hot lamination pouch thickness (80-175
micron) you wish to laminate.
175
125
80
100
5
175
125
80
100
4
175
125
80
100
7
175
125
80
100
3
2
1
6. While laminator is warming up, please
prepare item you wish to laminate. Place the
item inside the pouch and center it against the
sealed edge of the pouch. To prevent jamming,
use a carrier sheet when item is smaller than
the pouch.
8. Place pouch, sealed edge first, into
laminator entry. Keep pouch straight and
use the edge guide to centre it.
8
6
9. To prevent jamming, immediately remove
laminated item from back of machine. Let
item cool on flat surface for several seconds.
10. Before switching off laminator, feed
empty cleaning/carrier sheet through
machine to clean unit.
10
9
7. “Wait” LED ( ) will stop flashing
and acoustic bleep signal will sound when
machine is ready to laminate selected pouch
thickness.
5. Confirm your selection by pressing “Enter”
button in the middle of navigation keys.
“Wait” LED ( ) will begin flashing and
laminator will take a few minutes to reach
required temperature.