Istruzioni per l’uso e manutenzione instructions for use and maintenance gebrauchsanleitungen und wartung mode d’emploi et entretien instrucciones para el uso y manutencion instruÇÕes de utilizaÇÃo segatrice a nastro band-saw machine bandsÄgemaschine scie a ruban sierra de cinta serra de fita www.Fe...
Italiano (it) ............................................................................................................... 1 ÷ 6 english (en) ............................................................................................................. 7 ÷ 12 deutsch (de) ............................
7 en 1 introduction to use ...................................... 7 2 installation ......................................................... 8 3 adjustment .......................................................... 9 4 use ........................................................................ 10 5...
8 en 1.4 standard safety procedurs - do not use the machine in very damp places or in the presence of inflammable liquids or gases. - do not use it in the open air when general weather and environmental conditions are unfavourable (eg. Explosive atmospheres, during a storm or rain). - wear suitable ...
9 en 3 adjusting (fig. 4-5-6-7-8) 3.1 tension of the blade (fig.4) attention: the machine is fitted with a blade- tightening device that limits tension automatically. Turn handwheel b clockwise until the clutch engages 3.2 bar stop (fig.5) use the bar stop supplied if you have to do several cuts on ...
10 en now begin to apply gradual pressure on the part and complete the cut. Attention: always release button a between one cutting operation and another, while you are positioning the part. Do not try to block it or alter its functional characteristics in any way. If the machine suddenly stops after...
11 en section angle cutting 0 gradi 45 gradi 60 gradi 102 100 x 100 90 x 120 80 80 x 80 80 x 82 50 43 x 43 43 x 50 4.4 cutting capacity (fig.10) the table below specifies the cutting capacity at 0, 45 and 60 degrees which may be obtained in normal conditions of use described in this manual and witho...
12 en 6.2 assistence should it be necessary to call qualified personnel for operations of extraordinary maintenance, or in the case of repairs, under guarantee or at a later date, you should always contact an authorized service centre or the factory directly, if there is no service centre in your ar...
