Reference and owner’s manual for the deluxe 90
A message from the chairman since 1946, fender realized the importance of your amplifier. You see, your amplifier is more than just a combination of dials, wires and speakers. It is a finely tuned musical instrument. And like any fine musical instrument, it should be treated with special care and at...
90 watts of power @ 4 Ω two independent channels with independent tone controls “more drive” feature provides harmonically rich distortion for enhanced leads footswitch jack for remote on-off switching of the channel / drive selection spring reverb congratulations on your purchase of a fender deluxe...
Inputs 1 2 volume treble mid bass drive t more driv ch select volume a b c d e f g h i j k a. Input 1 - plug your guitar in here. B. Input 2 - a lower impedance and sensitivity input than input 1, useful for guitars with active pickups. C. Volume - adjusts the volume level of the normal (clean) chan...
Treble mid bass reverb ve pre out pwr in f e n d e r m u s i c a l i n s t r u m e n t s foot switch s l m n o p q r k. More drive - when this button is pressed in, drive channel gain is increased. L. Treble - adjusts the amount of increase or decrease in the high frequency range of the drive (disto...
360w a b power on off caution: chassis surface hot warning: to reduce the risk of fire or electric shock, do not expose this equipment to rain or moisture avis: risque de choc electrique ne pas ouvrir attention: superficie de chassis chaude 6 deluxe 90 rear panel a. Power switch - turns the ac power...
7 if the deluxe 90 is set up but does not function, check the following items: • is the power cord properly plugged into an electrical outlet? • is there power at the outlet? • are the control knobs turned above 1? • is the volume control on the instrument turned up? • are the control knobs on your ...
Type: pr 402 part numbers: 022-6702-020, (120v, 60hz), usa 022-6762-020, (230v, 50hz), europe 022-6742-020, (230v, 50hz), uk 022-6732-020, (240v, 50hz), aust. 022-6772-020, (100v, 50/60hz), japan power requirements: 360w power output: 90w into 4 Ω @ 5% thd input impedance: 850k Ω (input 1), 66kΩ (in...
