Fender Cyber-Twin Service Manual - page 10
CYBER-TWIN Service Manual
MIDI FOOT-PEDAL DOES NOT WORK
What to check:
- The MIDI RECEIVE CHANNEL on the Cybertwin is set to a different channel than the
transmitting MIDI device.
- The CONTINUOUS CONTROLLER on the Cybertwin is set to a different CONTINUOUS
CONTOLLER value on the foot-pedal.
- The CONTINUOUS CONTROLLER is switched to an incorrect control parameter.
How to solve the problem:
- Press the UTILITY menu button 5x to get to the MIDI RECEIVE CH function and set the
RECEIVE CHANNEL to the same channel as the transmitting device or set the RECEIVE
CHANNEL to OMNI.
- Press the UTILITY menu button 4x to get to the CONTINUOUS CONTROLLER function and
turn it to the same value as the foot-pedal.
- Press the AMP menu button 16x to get to the CONTINUOUS CONTROLLER function and turn
it to the parameter you would like to control.
DRY GUITAR SIGNAL ON SPDIF OUTPUT
What to check:
- SPDIF PATCHING is switched to GUITAR DIRECT OUT.
How to solve the problem:
- Press the UTILITY menu button 3x to get to the SPDIF PATCHING function and turn it to AMP
LINE OUT.
PROGRAM CHANGE DOES NOT WORK CORRECTLY
What to check:
- MIDI MAPPING is used incorrectly.
How to solve the problem:
- Press the UTILITY menu button 8x to get to the MIDI MAPPING function and map the correct
preset to the desired program change value.