Reference and owner’s manual for the sfx satellite.
A message from the chairman since 1946, fender realized the importance of your amplifier. You see, your amplifier is more than just a combination of dials, wires and speakers. It is a finely tuned musical instrument. And like any fine musical instrument, it should be treated with special care and at...
Congratulations on your purchase of a fender sfx satellite. Your new fender sfx satellite is designed by the same tone-team that has created many other classic fender amps: like the tone-master ® , princeton ® chorus and the versatile hot rod series. Built with care and special attention to detail, ...
Sfx satellite set-up procedure from preamp out to power amp in to sfx satellite input from sfx satellite output your fender sfx satellite offers endless possibilities for enhancing and creating new and exciting sounds from your traditional guitar rig. By following the set- up procedures listed below...
3. Next, place all knobs on your sfx satellite at 1 or their minimum positions. 4. Make sure the sfx on/off button pressed in (green light on) and the bypass button in its out position. 5. Play your guitar at your average volume through your rig. At this point, no sound will emanate from your sfx sa...
A. Input - plug your guitar amplifier’s preamp output or its effects send output in here. B. Dsp send - this knob adjusts the input level received from your guitar amp to the sfx satellite, setting the level of signal input to the digital signal processing card. Rotating the knob to the right increa...
Sfx satellite front control panel i. Bypass - this push-push button is the on / off switch for the bypass feature. When this button is pressed, the sfx and dsp effects are bypassed and the guitar amp’s signal is routed back to your amplifier. Note: refer to the chart below for the various configurat...
8 sfx satellite rear panel line cord - your sfx satellite is equipped with a grounding type supply cord to reduce the possibility of shock hazard. Be sure to connect it to a grounded ac receptacle. The line cord should be connected to a suitable power source in accordance with voltage and frequency ...
9 if the sfx satellite is set up but does not function, check the following items: • is the power cord properly plugged into an electrical outlet? • is there power at the outlet? • are the control knobs turned above 1? • is the volume control on the instrument turned up? • are the control knobs on y...
Type: pr 378 part number: 22-2001 (120v) 22-2031 (240v) aust 22-2041 (230v) uk 22-2061 (230v) eur 22-2071 (100v) power requirements: 100v ac, 50/60 hz 360w 120v ac, 60 hz, 360w 230v ac, 50 hz, 360w 240v ac, 50 hz, 360w power amplifier section power output: 80w r.M.S. Into 4 Ω @ preamp section input ...
Sfx matrix l r amp driver bypass output to guitar amp 12" side speaker pa hpf amp sfx bypass switch* sfx *for switch functions refer to the table on page 7. Dry bypass signal level sense dsp effect select dry driver signal present clip dsp send diff amp input from guitar amp + v + + + r l + + dsp re...
