Fender TBP-1 Owner's Manual - page 7
w
ww
ww
w.
.f
f e
e n
n d
d e
e r
r.
.c
co
om
m
✧
w
ww
ww
w.
. m
m r
r g
g e
e a
a r
r h
h e
e a
a d
d .
.n
ne
et
t
Front Panel Features:
•
Fender
®
passive tone stack (remember passive
means CUT ONLY)
•
•
Delivers that creamy tube tone
•
•
Volume, Bass, Mid & Treble controls for the
“clean” sound
•
•
Pull Deep and Bright boost switches
•
•
A (roughly) flat tone would be with the EQ set
Bass: 2, Mid: 10, Treble: 2, with no Deep or
Bright boosts active
•
Tube Overdrive section
•
•
Gain, Volume and Blend
•
•
This channel sits on top of the clean (which
preserves the warm clean pillow under the
overdrive)
•
•
Blend adjusts the clean vs. dirty ratio of the
tone (can be set “touch-sensitive”)
•
•
Footswitchable (4-button footswitch is
included)
•
Vari-Q™ section – A smart semi-parametric EQ
•
•
Cutting frequencies automatically DECREASES
the width of the Q for a narrow, defined cut
(notch)
•
•
Boosting frequencies automatically INCREASES
the width of the Q for a broader, more musical
boost
•
•
This intelligent Q control keeps “on the fly”
operation simple and effective
•
•
Footswitchable (4-button footswitch is
included)
•
Room Balance – Global EQ shift for cabinet/stage
response
•
•
Clockwise cuts lower frequencies while
simultaneously boosting upper frequencies
•
•
Counter-clockwise boosts lower frequencies
while simultaneously cutting upper frequencies
•
•
Room Balance Does NOT affect BALANCED
LINE OUT output (soundman gets unaltered
signal)
•
Master Volume – One level control that affects
everything (except Balanced Line Out, Tuner and
FX Send)
•
Mute
•
•
Cuts all signal except for the Tuner and FX
Send
•
•
Footswitchable (4-button footswitch is
included)
Rear Panel Features:
•
BALANCED LINE OUTPUT with Ground Lift and
Pre/Post switches and Level control
•
Jensen
®
Line Out Transformer (THE output
transformer for maintaining a clean Balanced Line
Out signal)
•
Tuner Send (always on, even when the MUTE is
engaged)
•
Effects Loop with Trim control and level shift
switch (can also be used as an adjustable boost
control)
•
•
Footswitchable (4-button footswitch is
included)
•
Bi-amp low and high sends with active crossover
(as big as you need it to be)
•
Full-Range Main Output
•
Footswitch input (4-button controls: Overdrive, FX
Loop, Vari-Q™ and Mute)
•
Additional Instrument Input on the back (in case
your rack setup prefers having the input
connection in the back)
Feature Set
7
T
T
T
T
B
B
B
B
P
P
P
P
--
--
1
1
1
1