1. DL manuals
  2. Fenix
  3. Swimming Pool Heater
  4. CH-2000B TURBO
  5. Safety & Operating Instructions Manual

Fenix CH-2000B TURBO Safety & Operating Instructions Manual

Summary of CH-2000B TURBO

  • Page 1

    1 these instructions are for your safety. Please read through them thoroughly before use and retain for future reference. Parts supplied ref description illustration qty a main body 1 b feet 2 c screw for feet 4 tools required (not supplied) cross head screwdriver before you start  check the pack a...

  • Page 2

    2 please read the following instructions carefully before using the appliance. • this appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction...

  • Page 3: Assembly Instruction

    3 • place the appliance on a flat, stable, heat-resistant surface. Operating the product in any other position could cause a hazard. • there may be trace of odour during the first few minutes of initial use. This is normal and will quickly disappear. • do not attempt to repair, disassemble or modify...

  • Page 4

    4 2. Insert the plug into a suitable wall outlet after turning the thermostat switch counter-clockwise to the minimum position and setting the heater switches and fan switch to “off”. The heater is suitable for operation on an electricity supply having the same voltage as that show on it’s rating la...

  • Page 5: Plug Replacement

    5 plug replacement  this appliance is supplied with a bs1363 3 pin plug fitted with a 13 amp fuse. Should the fuse require replacement, it must be replaced with a fuse rated at 13 amp and approved to bs1362.  in the event the mains plug has to be removed/replaced for any reason, please note: the w...

  • Page 6: Conformity With Directives

    6 2. Clean the exterior surface of the product by wiping it with a soft, damp cloth. Caution: allow the product to completely cool before handling or cleaning it. Ensure the product is in the “ 0 ” (off) position and the power cord is unplugged from the electrical outlet before cleaning the product....