Ferimex Outdoor Multi-Router 1-1 LITE Installation Manual - page 8
Ferimex Outdoor Multi-Router
8
Caution: Always install the outdoor unit with the arrow mark pointing UP. At the
bottom of device there is small aperture. Always keep this aperture facing down so
condensate moisture can leak out from the device. Otherwise the water may leak into
the device during the rain and damage the device. This kind of damage is not
covered by warranty.
Accessing the configuration
There are three ways to configure device:
a. Command Line Interface, which can be accessed over IP address using telnet
or SSH or over MAC address using MAC telnet
b. Winbox configuration utility, which can access to device over IP or MAC
address
c. Web based configuration, which can be accessed over IP address only, using
regular web browser
To access the configuration interfaces, make sure you are using the computer connected to
the same network as the device. The device has no default IP address assigned. Default
user name is admin and there is no password. If you configure the device for first time, use
the Winbox configuration utility, because it can search MAC address or IP address of the
device.
1. Winbox configuration utility - This is the most recommended method to
configure the device. The winbox.exe program is on the attached CD. You can
run this program natively on Windows operating systems or using WINE on Linux.
Put the IP address or MAC address of device in to the “Connect To” field. You
can use the “…” button to search MikroTik based devices in your network and
show their MAC and IP address. Then put user name to the “Login” field (default:
admin) and password to the “Password” field (default left blank). Then click
connect button.