Ferm 340470 User Manual - page 4
Ferm
17
MAINTENANCE
When the body repair kit is not in use, the pump
unit should be stored with the release valve open.
REFILL OIL
Fig.7
•
To check the oil level, place the pump unit in an
upright position, as indicated on the diagram. If requi-
red add hydraulic oil until it is level with the full mark.
•
Remove the dip stick and the oil level will be indica-
ted.
•
Your jack was filled at the factory with high grade
hydraulic oil. Only use approved oil.
After extensive use, the oil supply should be replaced
to ensure longer equipment life. To drain, remove
the dip stick and open release valve. Ensure that no
dirt gets into the system. Refill with approved oil.
MAINTAIN THE TOOL WITH CARE
The tool works best and safest if it is kept clean
Observe the instructions for maintenance and changing
accessories. Keep the tool dry and free from oil and gre-
ase.
Stay alert
Watch what you are doing, use your common sense, do
not operate the tool when you cannot keep your mind
on the job.
Check the machine for damage
•
Before starting the machine, check that all safety
devices and damaged parts operate smoothly and
efficiently.
•
Make sure all moving parts are in good working
order; check the machine for any broken or jamming
parts, make sure all parts are fitted properly and any
other conditions that might affect the functioning of
the machine are favourable.
•
If not stated otherwise in this manual, damaged safety
devices and machine parts must be repaired or
replaced by a recognized service centre. Damaged
switches must be replaced by a service centre. Do
not use the machine when it cannot be switched on
or off.
Have your tool repaired by an expert!
This electric appliance is in accordance with the relevant
safety rules. Repairing of electric appliances may be car-
ried out only by experts other wise it may cause conside-
rable danger for the user.
For your own safety use only accessories and
attachments recommended in this manual or the
catalogue. The use of other than the stated accessories or
attachments may cause injuries.
ENVIRONMENTAL PROTECTION
Recycling raw materials is preferable to dumping them as
waste. To prevent the machine from being damaged
during transport its packing must be strong. Insofar as
possible the packing consists of recyclable materials.
WARRANTY PROVISIONS
1. Ferm guarantees all material and construction
defects for a period of 36 MONTHS after purchase.
Other claims in respect of damage, of whatever
nature, direct or indirect, to persons and/or mate-
rials are excluded.
2. Always consult your Ferm dealer in the first instance.
Usually he will be able to solve the problem or repair
the defect.
3. If parts are repaired or replaced within the warranty
period, this does not extend the warranty period.
4. Fair wear and tear is not covered by this warranty.
For example motors, switches or bulbs.
5. This warranty applies only:
•
If you can submit proof of the date of purchase, i.e. a
receipt stating the date of purchase;
•
If you have completed and signed the enclosed war-
ranty card (in the back of this manual);
•
If no repairs or alterations have been made to the
machine by third parties, nor other than the original
parts have been fitted;
•
If the machine was used in accordance with the
instructions;
•
If we cannot plead force majeure.
6. The warranty provisions apply in combination with
our terms of delivery and sale.
7. All costs of transport of the machine to be repaired
are at the buyer’s expense. Badly packed articles are
not accepted.
Ferm’s After Sales Service
Save the original packing. Should you ever have to move
the machine there is less risk of damage in the original
packing. In the case of a warranty claim the machine can
be returned best in the original packing.
4
Ferm