Ferm FTB-13 User Manual - page 3
6
Ferm
SPARE PARTS LIST FTB-13
REF NR
DESCRIPTION
FERM NR
27
MOTOR
311053
37
MAGNETIC SWITCH
311051
50
COVER FOR SPRING
311059
51
SPRING
311058
56
CHUCK GUARD
311055
58
V-BELT
800157
10
CHUCK
311054
-
CHUCK KEY
311057
-
CONDENSER
311056
OPERATIONAL SAFETY
Concentrate
Do not allow routine, which occurs when using the
machine frequently, to lead to mistakes. Remember that
a slight lack of concentration can result in serious injuries
in a split second.
Keep work area clean
Cluttered areas and benches invite injuries.
Consider the work environment
Do not expose power tools to rain or use them in damp
or wet locations. Keep work area well lit. Do not use
power tools in the presence of flammable liquids, vap-
ours or gases.
Guard against electric shock
This unit contains dangerous voltages. Use a RCD (resi-
dual current device) to provide protection against elec-
trical shock. Prevent body contact with grounded sur-
faces (e.g. pipes, radiator, ranges or refrigerators).
Keep children and pets away
Do not let children or pets come into contact with the
tool, extension cable or work area.
Do not force the tool
It will work better and safer at the rate for which it was
intended.
Use the right tool
Do not force small tools or attachments to do the job of a
heavy-duty tool. Do not use tools for purposes for which
they were not intended; for example do not use a circular
saw for cutting trees or logs.
Do not abuse cable
Never carry tool by the cable or pull it to disconnect it
from the power socket. Keep cable away from heat, oil
and sharp edges. Do not touch the metal plug pins when
connecting or removing the plug.
Secure Work
Use clamps or a vice to hold work. It is safer than using
your hand and it frees both hands to operate the tool.
Do not over-reach
Keep a proper footing and balance at all times.
Disconnect tools from power supply
When not in use, before servicing and when changing
accessories such as blades, bits and cutters.
Always switch off and unplug the appliance from
the power supply when making adjustments
Remove adjusting keys and wrenches
Ensure that they are removed from the tool before swit-
ching on.
,
Avoid unintentional starting
Do not carry plugged in tools with your finger on the
switch. Check that the switch is off before plugging in to
socket.
Outdoor use extension cables
When the tool is used outdoors use only an extension
cable intended for outdoor use and marked accordingly.
Use a RCD (residual current device) to provide protec-
tion against electrical shock. Do not use in rain or damp
conditions.
Connect a dust extraction device
Whenever there are facilities for fitting a dust extraction
system, make sure it is connected and used.
Use recommended accessories
The use of any other accessory or attachment other than
recommended in the instructions or catalogue may pre-
sent a risk of personal injury.
Ferm
3