Ferris IS2100Z Series Operator's Manual - page 23
Fuel Injected Models: The fuel filter is located in the fuel line
between the fuel tank and fuel pump.
If filter is dirty or clogged, replace as follows:
1.
Disconnect the negative battery cable.
2.
Place a container below the filter to catch spilled fuel.
3.
Using a pliers, open and slide hose clamps from fuel filter.
4.
Remove hoses from filter.
5.
Install new filter in proper flow direction in fuel line.
6.
Secure with hose clamps.
7.
Reconnect the negative battery cable when finished.
Check Engine Oil Level
Interval: Before Each Use
Refer to the engine owners manual for dipstick and oil fill
locations and specific engine oil check and fill procedures.
Changing the Engine Oil and Filter
This series of mower has five different engine options: Briggs
& Stratton Vanguard Series (A, Figure 21), Briggs & Stratton
EFI Series (B), Kawasaki FX Series (C), Kohler EFI Series (D),
and Briggs & Stratton Vanguard Big Block Series (E). Please
reference figure 21 as the location of the components listed for
this procedure may vary by specific engine option.
21
1.
Warm engine by running for a few minutes. (Refer to the
engine operator’s manual for oil & filter replacement
instructions.)
2.
Remove the oil drain hose (F) from its storage position and
route the hose so that when the oil drain cap is removed
the oil can be drained into a small pan.
3.
Place a small pan under the oil drain hose to catch the oil.
Using the appropriate tools, remove the oil drain cap from
the oil drain hose and drain the engine oil.
4.
After draining, replace the cap and wipe up any spilled oil.
Reinstall the oil drain hose to its storage position so it is
retained during normal operation.
5.
Place an absorbent shop cloth under the engine oil filter
(G). Remove the engine oil filter and replace with a new
one.
6.
Add engine oil (refer to engine operator’s manual) in the fill
tube (H) and check the amount of oil in the engine using
the engine oil dipstick (I).
7.
Remove the shop cloth and wipe up any spilled oil.
Engine Maintenance
For engine maintenance schedules and procedures, please
refer to the engine operator's manual.
Electronic Fuel Injection (EFI) System - EFI
Models
EFI is an electronically-controlled fuel management system
which is monitored by an Electronic Control Unit (ECU). A
Malfunction Indicator Lamp (M.I.L.) will illuminate if problems
or faults are detected. Servicing by an authorized dealer is
necessary.
CAUTION
Do not disconnect or reconnect ECU wiring harness connector
or any individual components with the ignition switch in the
"ON" position. This can send a damaging voltage spike
through the ECU.
Unplug harness from ECU before performing any welding on
equipment.
Inspect Muffler and Spark Arrester
Inspect the muffler for cracks, corrosion, or other damage.
Remove the spark arrester, if equipped, and inspect for damage
or carbon blockage. If replacement parts are required, make
sure to use only original equipment replacement parts.
WARNING
Replacement parts must be the same and installed in the
same position as the original parts or fire could result.
Fuse Identification and Location
The fuse block is located on the right side of the machine by
the instrument control panel. Refer to Figure 22for the location
and amperage of the fuses used in this machine.
23