Ferris IS2100Z Series Operator's Manual - page 33
48
2.
Loosen the nuts (C) and allow the rear of the deck to rest
on the 2 X 4's. Slide the chains in the slots until the chains
are tight and tighten the nuts.
3.
Repeat the process for the other side of the unit.
4.
Remove all the blocks from under the mower deck.
5.
Perform the
Determining if the Deck Leveling Needs to Be
Adjusted procedure to verify that the deck has been levelled
correctly.
• If the measurements are greater than 1/8" (3,17 mm)
of what they should be perform the
Fine Adjustment
procedure.
Fine Adjustment
1.
Loosen the jam nut (A, Figure 48) and turn the fine
adjustment bolt (B) to adjust the deck height
• Turn the bolt clockwise to raise the deck
• Turn the bolt counter-clockwise to lower the deck.
2.
Once the desired measurement is achieved, retighten the
jam nut.
3.
Repeat the process for the other side of the unit.
Deck Lift Assist Springs
Some models are equipped with deck lift assist springs (A,
Figure 49) that assist the operator in raising the mower deck
with the deck lift pedal. The deck lift assist springs are factory
set to provide optimal lifting performance.
49
Although it is fastened with a multi-position anchor, this is not
an adjustment point.
Do NOT attempt to adjust the spring length or lifting performance
will be compromised.
Mower Belt Replacement
NOTICE To avoid damaging belts, do not pry over pulleys.
1.
Park the mower on a smooth level surface such as a
concrete floor. Disengage the PTO, engage the parking
brake, turn off the engine and remove the ignition key.
2.
Lower the mower deck to its lowest cutting position and
remove the mower deck guards and floor pan to gain access
to the mower deck belt.
WARNING
Use extreme caution when rotating the idler arm with the
breaker bar, due to the increased tension in the spring as the
idler arm is being rotated. Injury may result if the breaker bar
is prematurely released while the spring is under tension.
3.
Using a 1/2" breaker bar, place the square end in the square
hole located in the end of the idler arm (A, Figures 50 & 51)
• For 52" Models: Carefully rotate the breaker bar
counter-clockwise, which will relieve the tension on
the belt exerted from the idler arm.
50
• For 61" Models: Carefully rotate the breaker bar
clockwise, which will relieve the tension on the belt
exerted from the idler arm.
33