Ferroli boiler replacement optimax 25c- modena he.
Boiler replacement: optimax 25c to modena 32c he the installation must comply with the following; gas safety (installation & use) regulations the building regulations the building regulations (scotland) building regulations (northern ireland) the water fittings regulations or water byelaws in scotla...
Boiler replacement: optimax 25c to modena 32c he fig.1 fig.2 fig.3 manual handling when lifting take suitable safety precautions: keep your back straight, bend knees, do not turn your body, avoid bending forward or sideways and keep the load as close as possible to your body. Ideally seek assistance...
Boiler replacement: optimax 25c to modena 32c he 4. Disconnect and remove the flue from the existing boiler by undoing the four screws securing the appliance bend to the top of the boiler (fig.4) 5. Ensure that all pipe connections are free, move the base of the boiler forward and lift the boiler of...
Boiler replacement: optimax 25c to modena 32c he boiler pack contents installing the new modena c he modena 32c he dimensions 1. Check the existing flue terminal position with regard to possible nuisance “pluming”. 2. Unpack the boiler and check the contents are complete and undamaged (see opposite)...
Boiler replacement: optimax 25c to modena 32c he fig.6 5. Lay the boiler on its back. Remove the front casing panel by undoing the two securing screws on the underside of the case. Ease the lower edge of the panel forward to clear the controls display and lift upwards off the frame. 6. Lift the boil...
Boiler replacement: optimax 25c to modena 32c he 9. Remove the condensate bowl and hose from the boiler fittings pack. Undo plastic nut (fig.9-a) and fit the condensate bowl and washer. Push on the rubber condensate hose to the trap outlet (fig.9-b). 10. Connect the safety valve outlet (fig.9-c) to ...
Boiler replacement: optimax 25c to modena 32c he 13. Open the cold water isolation valve and thoroughly flush the cold/hot water pipe-work by opening all the hot taps. 14. Reinstate the gas supply, purge and test in accordance with bs 6891 and ige/up/1. 15. Connect the boiler to the electrical suppl...
Boiler replacement: optimax 25c to modena 32c he fig.13 fig.14 fig. 15 sample points: 1 = air / 2 = flue gas 16. Commissioning the boiler: (see 3.3 of the modena c he installation instructions) connect a manometer to the inlet test point of the gas valve (fig.13) set the boiler to operate at maximum...
Ferroli ferroli limited lichfield road branston industrial estate burton on trent de14 3hd www.Ferroli.Co.Uk boiler replacement calls to the above numbers are charged at national rate from bt landlines. Calls from mobile networks may be considerably more. Whilst every effort is taken to ensure the a...
