Fervi 0500 Translation Of The Original Instructions - Introduction
MACHINES AND
ACCESSORIES
Pagina 5 di 32
1
INTRODUCTION
This manual is delivered with the machine, and it must be regarded as an inseparable part of
it.
The manufacturer holds all ownership to material and intellectual property of this manual;
any disclosure or copying, even partial, of this publication without prior written consent is
forbidden.
The purpose of this manual is to convey the necessary knowledge for the use and
maintenance of Electronic cutting band saw for bench Art. 0500 and to create a sense of
responsibility and knowledge of the capabilities and limits of this machine entrusted to the
operator.
Operators must be properly trained and prepared; therefore, please make sure this manual is
read and consulted by the staff responsible for commissioning, operating and maintaining the
Electronic cutting band saw for bench. This is to make all operations the safest and most
effective possible for those who carry out these tasks.
Therefore, it is imperative to strictly comply with the requirements in this manual, a
necessary condition for safe and satisfactory operation of the machine.
Prior to installation and use of the Electronic cutting band saw for bench, the authorized
personnel shall:
carefully read this technical document;
know which protections and safety devices are available on the machines, their location
and how they work.
It is the responsibility of the buyer to ensure that users are properly trained, that they are
aware of all the information and instructions in this document and that they are aware of the
potential risks that exist while working with the Electronic cutting band saw for bench.
The manufacturer waives any and all responsibility for damage to people and/or
things caused by non-observance of the instructions in this manual.
The Electronic cutting band saw for bench has been designed and built with mechanical
guards and safety devices designed to protect the operator/user from possible injury. It is
strictly forbidden to modify or remove guards, safety devices and caution labels. If you have
to do so temporarily (for example, for cleaning or repair requirements), please make sure
that no one can use the machine.
Modifications to the machine carried out by the user must be considered their sole
responsibility, therefore the manufacturer waives any and all responsibility for any
damage caused to persons and/or property resulting from maintenance performed
by unqualified personnel and in a manner unlike the operating procedures shown
below.