Fervi 275 Original Instruction - Fervi.Com
MACHINES AND
ACCESSORIES
Page 8 of 44
1. Always check the efficiency and integrity of the machine.
2. Before connecting the machine to the mains, make sure that the blade is not damaged
or badly worn. Make sure that the switch is in the neutral position.
3. Do not start the machine in an enclosed or poorly ventilated area, or in the presence of
a flammable and/or explosive atmosphere. Do not use the machine in damp and/or wet
locations, or those exposed to rain or humidity.
It is prohibited to install and use the machine outdoors.
4. User advance, check that the bearing surface of the machinery results flat, of suitable
strength and of sufficient ergonomics: for this purpose made with the aid of a
workbench.
5. Secure the workpiece. Use the vice on the machine to keep the workpiece stable.
6. Avoid starting accidentally.
7. Before starting the machine, get used to ensuring that no remaining maintenance and
service keys are inserted.
8. Connect dust extraction equipment. Make sure a vacuum is connected to the machine,
for the suction of dust and chips produced.
9. Keep the workplace tidy and free from obstruction; disorder causes accidents.
10.Make sure that your work environment is forbidden to children, strangers and animals.
11.Do not perform tasks on the machine other than those for which it was designed. Only
use the machine in the manner in which it was intended, as described in this instruction
manual.
In particular, do not use the mitre saw to cut material other than wood!
12.Before starting work, inspect the piece and remove any foreign material.
13.Remain balanced whilst working.
14.Work areas must be well lit.
15.Always wear eye protection and protective gloves while working. If dust is produced,
use the appropriate masks.
16.Wear appropriate clothing. Loose clothing, dangling jewellery, long hair, etc., can get
caught in the moving parts or the disc, causing irreparable injury.
17.Do not leave the machine until the disc has completely stopped. For this purpose, only
use the stop controls to stop the machine.
18.Do not slow down or stop the disc with your hands or other objects.
Allow the disc to stop on its own!
19.Take proper care of the cutting tools. Cutting tools must be kept intact and clean to
ensure the best possible performance.
20.Never use blades that are less than 2.7 mm thick.
21.Never use the blades for materials other than wood.
22.Replace worn and/or damaged parts, check that the repairs and protections work
properly before operating. If necessary, have the machine checked by the service
support personnel. Use only original spare parts.
23.Unplug the power cord of the machine from the power outlet when:
the machine is not being operated;
it is left unattended;
performing maintenance or registration, because the machine does not work
properly;
the power cable is damaged;