Fervi 444 Operation And Maintenance Manual - 4 Commissioning
HARDWARE
Page 7 of 9
4 COMMISSIONING
4.1 Installation
Open the plastic case containing the paint stripper and all the accessories. Lay the paint
stripper on the workbench.
5 HOW TO USE
5.1 Power On / Off
Insert the plug into a 230 V (50 Hz) socket.
To remove the plug, hold it by the body and never pull by the
cord.
To turn on the paint stripper, it is necessary to push the four-
position switch located on the back of the handle from position 0
to position I, II or III according to the volume of air and the
desired temperature.
To switch off the device, turn the switch to the "I" position for 3
minutes, then turn the switch to "0".
After work is completed, always unplug the paint stripper and
leave to cool completely before storing in the box.
Figure 2 – Power supply
connection
5.2 Using the paint stripper for "stripping paint"
Personal Protective Equipment (PPE)
Before using the paint stripper, wear suitable clothing, a mask, gloves and goggles.
Figure 3 – Power supply connection
Workspace
Be familiar with the work area. The areas behind ceilings, floors, etc. can easily hide
flammable materials. Always check these areas before using the device. Keep the work area
clean, uncluttered and well lit.
Smoke may come out of the body of the paint stripper the first time it is turned on.
The first few times, you may want to use the paint stripper on a very small area and verify
the results before proceeding to larger areas.
fervi.com