Wine cabinet 50 vl instructions for installation and use it is strongly adviced that these instructions be read carefully prior to the installation and operation your new freezer..
2 safety precautions ......................................... 3 stipulations for use ....................................... 3 before starting to use the cabinet ......... 4 installing the wine cabinet.......................... 4 location................................................................
3 when cleaning the wine cabinet, switch off the voltage using the main switch and remo- ve the plug from the socket. Materials that are liable to explode must not be kept in the wine cabinet. The door must not be opened beyond 120 º, because this may cause the hinge bush- ing to break on hitting th...
4 warning! The appliance contains a small amount of environment-friendly but flammable coolant, r600a. This coolant will not damage the ozone layer, nor will it cause a greenhouse effect. Please check that the coolant piping has not become damaged during trans- portation or installation. Leaking coo...
5 note! Check that the end of the defrost water pipe a is in the trough on top of the compressor. Electric connection the wine cabinet is connected to an eart- hed (grounded) electric socket (single phase, 230v, 50 hz) using the connecting lead of the appliance. The fuse size for the socket is 10 a....
6 balancing push the wine cabinet into place and balance it with the aid of the adjusting legs at the front edge (see illustration). Fitting the bottom front plate fix the bottom front plate in place. Shelves of the wine cabinet the shelves can be removed by lifting them out. Adjustment of the door ...
7 functioning of the cooling mechanism the cooling mechanism consists of the compressor, the condenser and the ex- pansion coil; these form a closed circuit in which the compressor circulates the coolant. In the expansion coil, the coolant is vapo- rized and binds heat to itself, cooling the cabinet...
8 before using the cooling cabinet, clean its interior parts, following the instructions on p. 11. Do not start to use the appliance imme- diately after transportation or after it has been kept in a cold place, but let it stand in its final location for a few hours so that the oil has time to flow d...
9 the temperature that has been set can be brought into view by pressing upper button of the display for about 2 seconds. The display will begin to flash, showing the set temperature. After a while, the flashing will stop and the set temperature will remain in force. Adjusting the temperature • pres...
10 cleaning and service note: stop the mechanism by using the main switch, and always take the plug out of the wall socket for the period during which cleaning or other maintenance work is being done. Cleaning the mechanism pull the cooling cabinet away from the wall. Remove dust and other dirt from...
11 if the light inside the cabinet does not work: • the lamp is broken -replace the lamp. Lamp type: pl tube 7w, base g 23 changing the lamp: • stop the mechanism using the ope- rating switch of the cabinet • take the plug out of the wall socket • disconnect the plastic lid of interior light by open...
Suomen kotikylmiö oy, ravitie 3, 15860 hollola, finland tel. +358 (0)3 553 8600, fax +358 (0)3 553 8668 www.Festivo.Fi.
