Festool TS 55 REBQ Original Operating Manual - Environment

TS 55

19

GB

Adjust the guide play between the saw table and

the guide rail using the two adjustable jaws [9-

1].

Bed in the splinterguard [9-3] before using the

guide rail for the first time:

Set the machine speed to 6.

Place the machine at the rear end of the guide

rail together with the complete guide plate.

Switch on the machine. 

Push down the machine slowly to the max. pre-

set cutting depth and cut along the full length of

the splinterguard without stopping.

The edge of the splinterguard now corresponds ex-

actly to the cutting edge.

11

Environment

Do not dispose of the device in house-

hold waste! Recycle devices, accesso-

ries and packaging. Observe applica-

ble country-specific regulations.

EU only: European Directive 2002/96/

EC stipulates that used electric power tools must

be collected separately and disposed of at an envi-

ronmentally responsible recycling centre. 

Information on REACh: www.festool.com/reach

12

EU Declaration of Conformity

We declare under sole responsibility that this prod-

uct complies with the following directives and stan-

dards:

2006/42/EG, 2004/108/EG, 2011/65/EU (from

01.01.2013), EN 60745-1, EN 60745-2-5, EN 55014-

1, EN 55014-2, EN 61000-3-2, EN 61000-3-3.

Festool Group GmbH & Co. KG

Wertstr. 20, D-73240 Wendlingen, Germany

Dr. Martin Zimmer

Head of Research, Development and Technical

Documentation 

29.11.2012

Plunge-cut saw

Serial no.

TS 55 REBQ

498500

TS 55 REQ

498875

TS 55 RQ

498521

Year of CE mark: 2011