Fetco GR Series User Manual - page 10
10
Figure 3 – GR-1 & GR-2 Motor Assy. – Type A
Parts List – Figure 3
ITEM QTY PART
NO.
Description
1 2 56012
COVER
SCREWS
2 2 56013
COVER
WASHERS
3
1
56011
COVER ASSEMBLY FOR GRINDING CHAMBER (includes K042 bearing assy.)
(3)
1
K042
BEARING ASSEMBLY (includes bearing and adjustment shaft)
(inside ITEM #3 – cover assembly)
4 1 56014
ROTOR
SCREW
5 1 56015
ROTOR
WASHER
6
1
56009
ROTATING DISC FLANGE WASHER
7
NA
NA
ROTOR ASSEMBLY – NOT SOLD AS A COMPLETE ASSEMBLY
8 1 85010
AUGER
SPRING
9
6
82161
GRINDING DISC MOUNTING SCREWS
10
1
14006
GRINDING DISC, SET OF TWO
11 1
NOT AVAILABLE
GRINDING CHAMBER HOUSING ASSY. (SEE NOTE BELOW)
12
1
56008
ROTATING DISC FLANGE (ALSO REQUIRES #20 – 24049 GRINDING RING)
13
1
87018
MOTOR SHAFT PIN
20
2
24049
GRINDING RING, HDPE
NOTE: Item # 11 - GRINDING CHAMBER HOUSING is no longer available. Grinders that require this part must be
retrofitted to the Type B configuration shown in Fig. 4. The existing motor can still be used.
To retrofit the grinding chamber, order part # K078 – GRINDING CHAMBER RETROFIT KIT.
The complete Type A MOTOR ASSEMBLY shown above is no longer available. Grinders that require a
new motor must be retrofitted to the Type B motor shown in Fig. 4.
To retrofit the entire motor assembly, order part # K077 – MOTOR ASSEMBLY RETROFIT KIT.
*
NOTE: ITEM # 20 IS OPTIONAL,
NOT REQUIRED FOR
REVISED GRINDING DISCS.
*
*