Fetco GR Series User Manual - Installation
3
Installation
Warning: Read this User’s Guide before installing. Damage caused by improper installation will not be
covered under warranty.
1. Inspect the container for visual or hidden damage. The carrier must be notified of any punctured or
damaged cartons immediately.
2. Install the grinder in selected location making sure surface is level, and that grinder will fit.
Caution: Never
push equipment against cords or wall outlets.
3. Remove cord from inside hopper and plug into the back of the grinder.
4. Before plugging grinder into 120 volt, 15 amp. wall outlet make sure
outlet is not overloaded, a dedicated circuit is preferred.
5. Following the operating procedures below test grinder for proper
operation.
6. If you need further assistance please call our Technical Support
Dept. at 800-338-2699 or e-mail techsupport@fetco.com.
Operating Instructions
1. Turn grinder on/off switch to the on position.
• The power switch will illuminate to indicate that the grinder has power and is operational.
2. Fill the hopper(s) with whole coffee beans.
• The GR-2 models have two 5lb. removable hoppers. These hoppers must sit squarely on the floor
of the hopper chamber. When placing the hoppers inside the hopper chamber make sure chamber
is clear of stray whole beans and debris. The hoppers will not sit properly if this is not done.
• Both hoppers must be placed into the grinder before operating grinder; and plastic covers must be
on hoppers.
3. Place the brew basket with paper coffee filter in the plastic holding arms.
• The plastic arms will hold all FETCO brew baskets up to 52H models; and will fit most all other
manufactures.
• All other sizes, FETCO recommends placing paper coffee filters on lower shelf and grinding
directly into filter.
4. Press portion switch. (Factory Defaults)
• Small portion: 4 ounces
• Medium portion: (Available only on GR-1.3 and GR-2.3.) Approximately 6 ounces
• Large portion: 8 ounces
5. Allow grinder to complete its cycle then remove brew basket from plastic holding arms.
Cleaning:
a) Use stainless steel cleaner on all stainless steel surfaces. (Never use abrasives on these surfaces.)
b) Use damp cloth on other surfaces. Use mild detergent as needed.
c) Removable hoppers on GR-2 models are dishwasher safe (the covers are not).
d) After washing hoppers FETCO recommends hand drying them.
Service and Support
For service and support information, contact the Technical Support department. Our hours are 7:00 AM to 6:00 PM
Central Time, Monday through Friday. Phone: (800) 338-2699 or (847) 719-3000. Email: techsupport@fetco.com.
Utilize only qualified beverage equipment service technicians for service. A Service Company Directory may be
found on our web site, http://www.fetco.com.
Warranty
All FETCO grinders come with a limited warranty. Warranty service must be authorized by the Technical Support
Department. A Return Authorization number will be issued for all parts replaced under warranty.
Warning: To prevent
electrical shock, this
unit must be properly
grounded.