FHF HS14 User Manual - page 3
3
Betriebsende
Durch Drücken der Lautsprechertaste wird das Gespräch
beendet. Nehmen Sie das
Ex-Headset
ab. Wickeln Sie die
Verbindungsleitung auf und hängen Sie sie zusammen mit
dem
Ex-Headset
auf den Bügel. Der
Headset B
etrieb ist
durch Trennen des Verbindungssteckers des
Ex-Headsets
von der Anschlussleitung beendet.
End of Operation
You terminate the conversation by pressing the loudspeaker
key. Take off the Ex-headset. Coil the connecting cord and
hang it on the bracket together with the Ex-headset. You
terminate the headset mode if you disconnect the
connecting plug of the Ex-headset from the connecting cord.
ExResistTel IP2 / IP154
Inbetriebnahme und Betrieb
Um das Ex-Headset benutzen zu können, muss auf dem
Telefon mindestens die Software V9 Release [9.061421]
installiert sein. In der Web Oberfläche des Telefons muss
unter Device/Headset der Headset Typ auf ‚Imtradex/Ecom
Instruments‘ eingestellt sein. Weiterhin muss das Headset in
der Konfiguration des ExResistTel IP2 / IP154 freigegeben
werden. Gesteuert wird Verwendung des Headsets für
Telefongespräche über die Headset Taste (Taste
lang
(länger als 1 Sekunde) und anschließend die Lautsprecher-
taste drücken.).
Das Telefon ExResistTel IP2 / IP154 erlaubt das Telefonieren
mit einem angeschlossenen und freigegebenen Headset
zusätzlich zu verschiedenen Betriebsarten.
1. Hörerbetrieb
Beim Hörerbetrieb wird das Gespräch mit dem Hörer
geführt.
2. Hörerbetrieb mit Lauthören
Beim Hörerbetrieb mit Lauthören wird das Gespräch mit
dem Hörer geführt. Der im Telefon befindliche Laut-
sprecher wird dazugeschaltet. Im Raum anwesende
Personen können das Telefongespräch mithören.
3. Freisprechen
Beim Freisprechen wird das Gespräch über Mikrofon
und Lautsprecher des Telefons geführt. Alle im Raum
anwesenden Personen können am Telefongespräch
teilnehmen.
4. Headset Betrieb
Beim Headset Betrieb wird das Gespräch mit dem Ex-
Headset geführt.
5. Headset Betrieb mit Lauthören
Beim Headset Betrieb mit Lauthören wird das Gespräch
mit dem Ex-Headset geführt. Der im Telefon befindliche
Lautsprecher wird dazugeschaltet. Im Raum anwesende
Personen können das Telefongespräch mithören.
Die jeweils aktive Betriebsart wird in der Statuszeile des
Telefons angezeigt.
Um beim Hörerbetrieb zum Hörerbetrieb mit Lauthören zu
wechseln, drücken Sie während eines Gespräches die
Lautsprechertaste .
Um beim Hörerbetrieb mit Lauthören zum Hörerbetrieb zu
wechseln, drücken Sie während eines Gespräches die
Lautsprechertaste .
Um beim Hörerbetrieb (mit oder ohne Lauthören) zum
Freisprechen zu wechseln, ist die Lautsprechertaste
zu
drücken und bei gedrückter Lautsprechertaste der Hörer
aufzulegen. Danach kann die Lautsprechertaste
losgelassen werden.
Um beim Hörerbetrieb (mit oder ohne Lauthören) zum
Headset Betrieb zu wechseln, ist die Headset Taste (Taste
lang (länger als 1 Sekunde) und dann die Lautsprechertaste
) zu drücken. Danach kann der Hörer aufgelegt werden.
Um beim Freisprechen zum Hörerbetrieb zu wechseln, ist der
Hörer abzuheben.
Um beim Freisprechen zum Headset Betrieb zu wechseln, ist
die Headset Taste (Taste lang (länger als 1 Sekunde) und
dann die Lautsprechertaste ) zu drücken.
Um beim Headset Betrieb zum Headset Betrieb mit
Lauthören zu wechseln, drücken Sie während eines
Gespräches die Lautsprechertaste .
Um beim Headset Betrieb mit Lauthören zum Headset
ExResistTel IP2 / IP154
Commissioning and Operation
For using the Ex-headset at the phone it must be installed at
least the software V9 release
[9.061421]. At the web
interface of the phone the headset type must be configured
to ‘Imtradex/Ecom Instruments‘. Furthermore the
Ex-
headset must be enabled in the configuration of the
ExResistTel IP2 / IP154, to be used. The use of the headset
for calls will be controlled with the headset key (key long
(longer than one second) and afterwards press the
loudspeaker key
.).
The phone ExResistTel IP2 / IP154 allows making calls with
a connected and enabled headset additional to different
operating modes.
1.
Handset mode
At handset mode the call will be operated with the
handset.
2.
Handset mode with open listening
At handset mode with open listening the call will be
operated with the handset. The loudspeaker of the
phone will be turned on additionally. Persons present
in the room can listen to the call.
3.
Hands free mode
At hands free mode the call will be operated with the
microphone and the loudspeaker of the phone. All
persons present in the room can take part to the call.
4.
Headset mode
At headset mode the call will be operated with the Ex-
headset.
5.
Headset mode with open listening
At headset mode with open listening the call will be
operated with the Ex-headset. The loudspeaker of the
phone will be turned on additionally. Persons present
in the room can listen to the call.
The already active operating mode will be displayed in the
state line of the phone.
To change from handset mode to handset mode with open
listening, you have to press the loudspeaker key during a
call.
To change from handset mode with open listening to
handset mode, you have to press the loudspeaker key
during a call.
To change from handset mode (with or without open
listening) to hands free mode, you have to press the
loudspeaker key and hang up the handset with pressed
loudspeaker key . Afterwards the loudspeaker key can
be released.
To change from handset mode (with or without open
listening) to headset mode, you have to press the headset
key (key
long (longer than one second) and then the
loudspeaker key ). Afterwards the handset can be hung
up.
To change from hands free mode to handset mode, you
have to lift off the handset.
To change from hands free mode to headset mode, you
have to press the headset key (key long (longer than one
second) and then the loudspeaker key ).
To change from headset mode to headset mode with open
listening, you have to press the loudspeaker key during a
call.