Fhiaba Refrigerator User Manual - page 11
9
4
4.3
4.4
4.2
www.fhiaba.com ∙ info@fhiaba.com ∙ Info Line 800-344222 ∙ Tel +39 (0)434 420160 ∙ Fax +39 (0)434 420161
An integrated control system provides information through lighted
signals or text messages visualized on the display.
The information signal is always visualized with a fixed text message,
while a malfunction signal is visualized with blinking text. The sound
signal that accompanies some malfunction signals can be deactivated
by pressing the Alarm button on the main control panel.
The list of malfunction signals is located at the back of this manual.
Appliance switching on and off
Each model has been carefully tested before leaving the factory
and is adjusted in such a way to ensure high performance and low
consumption. Usually, it is not necessary to modify the settings.
Nevertheless, according to special needs, it is possible to modify
the set temperatures as follows:
Refrigeration Compartment
Fresco Compartment
Freezer Compartment
(TriMode)
From +2°C to +8°C (from 35.6°F to 46.4°F), the recommended preset
temperature is +5°C (41°F).
To adjust the temperature use the Up/Down buttons . Upon touching
these buttons the newly set temperature will appear in the display.
To modify this temperature, use the buttons until reaching the desired
temperature.
From -2°C to +2°C (from 28.4°F to 35.6°F), the recommended preset
temperature is 0°C (32°F).
To adjust the temperature use the Up/Down buttons . Upon touching
these buttons the newly set temperature will appear in the display.
To modify this temperature, use the buttons until reaching the desired
temperature.
From -15°C to -22°C (from 5°F to -7.6°F), the recommended temperature
is preset at -18° (0°F).
To adjust the temperature use the Up/Down buttons . Upon touching
these buttons the newly set temperature will appear in the display.
To modify this temperature, use the buttons until reaching the desired
temperature.
In case the compartment is used as refrigerator or Fresco compartment
(TriMode function) the recommended and preset temperatures will
correspond to those indicated for the respective compartments.
The temperature shown can vary slightly
in respect to the set temperature following
frequent openings of the doors or insertion of room
temperature foods or large quantities of foods.
6 to 12 hours are necessary to reach the selected
temperature.
Ice Maker Activation
That Icemaker button located on the main control panel permits
activation of the automatic icemaker. The button is lighted when the
icemaker is functioning.
A prewash of the hydraulic circuit should be performed before
activating the Ice Maker for the first time. To do this touch at the same
time buttons Enter and Ice Maker .
After a few minutes the Ice Maker can be activated.
Information and malfunction messages on the display
How to adjust the temperature for different requirements
Do not activate the Ice Maker unless the
appliance is connected to the water mains.