Foxtel STU 720if Operating Instructions Manual - page 10
OPERATING INSTRUCTIONS
STU 720if
10
STU, VCR, TV, Hi-Fi (using RCA Connectors)
NOTE:
It is recommended that you switch off the mains
supply to the STU before connecting or
disconnecting the LNB.
1
Connect the terrestrial antenna to the RF IN socket on the STU.
2
If required, using an RF flylead , connect the RF OUT on the STU
to the RF IN on the VCR.
3
Using another flylead, connect the RF OUT on the VCR to the
RF IN on the TV.
4
Connect the coaxial cable connector from the LNB on the
satellite dish into the socket marked LNB IN on the STU. Tighten
the connector finger tight.
5
If the TV and VCR have AV connectors, connect as shown in
the diagram.
6
Connect the VIDEO OUT connector on the STU to the VIDEO IN
connector on the VCR.
7
Connect the MONO AUDIO socket on the STU to the AUDIO IN
socket on the VCR.
8
Switch power on to the STU.
NOTE:
1. If your VCR has a stereo audio input
,
connect
the FIXED stereo audio outputs from the STU to
the VCR stereo audio connector.
2. Any taping of programmes from your Foxtel
service is subject to copyright laws.
3. Please note that when using the system with
fixed stereo connection, the volume control
cannot be controlled by the Foxtel remote
control unit. This will ensure appropiate sound
levels are recorded when taping programmes.
4. If you wish to use the Foxtel remote control
unit as the master volume control unit, connect
the variable stereo outputs. In this mode care
must be taken that there is sufficient audio level
when recording.
5. Your Foxtel installer will configure your
installation according to current Foxtel guidelines
and your particular TV and VCR.
Republic of South Africa
WARNING! High Voltage
DANGER! Do not open
Unauthorised opening
renders warranty invalid
Protect against moisture
REAR PANEL
N4078
RF IN
RF OUT
RF IN
TV
R
L
VIDEO
L
R
VIDEO
VCR