Fracarro CIR-AHD 3.6 Quick Manual - page 6
6
Infrared
Number and type of led
24 (Ø 5mm)
30 (Ø 5mm)
54 (Ø 5mm)
Projection distance
10 – 15 m indoor
5 – 10 m outdoor
20 – 30 m indoor
15 – 20 m outdoor
30 – 40 m indoor
25 – 30 m outdoor
Checking ignition
Light sensor CDS, with regulation D>N N>D
General data
Level of protection
IP66
Power
12 Vdc +/- 10%
Absorption maximum
(IR Led Off/On)
100 / 200 mA
100 / 300 mA
100 / 400 mA
Temperature and humidity of operation
-10 ~ +50 °C (Ur 85% max)
Size (WxHxD)
180 x 69 x 55 mm
228 x 97 x 65 mm
260 x 110 x 65 mm
Weight net/gross
450 g
700 g
850 g
Warnings
Not orient the camera toward the sun
Direct exposure to the sun or other light sources could damage the device. Handle with care - Shock improper could damage
the camera
Water protection and moisture.
The camera can not be opened to not reduce the seal. When adjusting the focus and zoom, be careful not to damage the
rubber seals, to avoid compromising the water resistance. The cable with all connectors (Video and Power) is not waterproof
and must be protected from the elements in a sealed housing.
Power - Be sure to respect the positive and negative polarity, as 12V from symbol, in the wiring of
taking power
Normative - In conformity with standard EN 50130-4(European directives 2004/108/EC - EMC).
In accordance with the European Directive 2004/108/EC (EMC), the product shall be installed using devices, cables and
accessories that allow to comply with this directive requirements for fixed installations
Qualified people
The product must be installed only by qualified people, according to the local safety standards and regulations.
Only instructed and authorized people can open the product. In case of failure, do not try to repair it otherwise the guarantee
will no longer be valid.
Installation instructions
Camera mounting
•
Fix the bracket by screws and adjust the camera direction using the dedicated tool for bracket screws.
•
Protect the cable, the OSD joystick and the connectors (Video and Power) from the water. A waterproof box is highly
recommended to protect from sun, rain and humidity all the parts outside the bracket.
Lens adjustment ref. pg. 15
•
Use screws: adjust the opening angle of the lens with the screw ZOOM.
•
Use screws: adjust the focus by screw FOCUS
•
See the table of different field of view (widht) for different target distance (D).
D = Target distance
Field of view (width)
[m]
D=5 m
D=10 m
D=15 m
D=20 m
D=25 m
D=30 m
D=35 m
D=40 m
CIR-AHD 3.6
3,6 mm
6,7m
13,3m
20m
26,7m
33m
40m
46,7m
53,3m
CIR-AHD 312 2,8–12mm
8,6–2m
17–4m
26–6m
34–8m
43–10m
51–12m
60–14m
68–16m
CIR-AHD 922 9 - 22 mm
2,7–1,1m
5,3–2,2m
8–3,3m
10,7–4,4m
13,3–5,5m
16–6,5m
18,7–7,6m
21,3–8,7m
OSD MANAGEMENT
Advanced settings are available by joystick on the cable
Up
Move up / increase values
Down
Move down / decrease values
Left
Open sub-menu
Right
Close sub-menu
Enter
Enter menu and confirm selection