Francotyp-Postalia optimail 30 Installation Manual - Step 4
Authorisation (Cont…)
Authorisation
It takes some time to establish the connection
and to authorise your optimail 30. Please
stand by.
The optimail 30 displays a message when
the authorisation was successful and
prompts you to load postage.
•
Select CONTINUE to start the Teleset
Process. (i.e. Download funds onto
your franking machine).
13
If you ordered an optimail 30 with integrated
scale, the scale comes mounted to the
franking machine on delivery. You need only
attach the scale platform.
•
Hold the scale platform so that the long slot
in the scale platform foot points to the right
(towards the display).
•
Place the scale platform onto the scale
receptacle from above. The long slot of the
scale platform must slide in the counterpart
on the scale receptacle.
•
Press down slightly on the scale platform
with your flat hand.
Step 4
Mounting the scale platform
6
Check your Modem Settings
The illustration is an
example of a Modem
Parameter overview.
The Phone Type is set to EXTENSION.
The Access Method is set to EXCHANGE
DIGIT.
The Exchange Digit is set to dial a ‘0’ and
the comma denotes a 2 second wait.
i.e. the franking machine will dial a ‘0’ and
then wait for 2 seconds before dialling the
Teleset modem number which is
programmed into the machine at the factory.
To go back and change these settings
again, press the CANCEL Soft Key 3.
Once you are happy that your settings
match the requirements of your telephone
line, and will allow the machine to access an
outside line, then press SAVE Soft Key 4.
Once the SAVE option is pressed the franking machine will attempt to
establish a connection to the Teleset data system which will register
your machine’s warranty and authorise your account.