Francotyp-Postalia ultimail Quick Install Manual - page 6
Calibrate the ink cartridges
8
Step
Determine the number on the test
imprint where the vertical lines are
the straightest Enter the determined
number with numeric keys.
The entered number appears in the
display after “Your input:”
Read the text in the display very
care-fully.
Then select:
TEST NEW ADJUSTMENT, to
repeat the adjustment if the lines
are still not perfectly straight or
END ADJUSTMENT PROCEDURE.
If necessary, repeat the adjustment
several times until the cartridges are
correctly aligned.
Once the power cable and the telephone cable have been connected, you can
now switch the machine on using the power switch at the rear of the Ultimail
The screen below will be displayed,
BYPASS ANY ERROR MESSAGES AT
THIS TIME BY PUSHING THE ‘ENTER’ BUTTON
The first thing you need to do is connect the Ultimail to our re-crediting centre.
If your telephone line requires a 9 to reach an outside line, you can continue
to
step 6 as the machine is already programmed to do this
If your telephone system is a direct line out you will need to set the Ultimail to
do this, continue to
step 5
Switching the machine on
4
Step
Both horizontal and vertical lines should be
equal to 5 before ending
calibration