Franke F3D3 User manual - page 30
30
07/2015
Frozen fry dispenser F3D3S/F3D3/ F3D3SP/F3D3P
en
Problem
Cause
Remedy
2
The freezer is
running but
cannot reach the
required operat-
ing temperature
(-18 °C).
Ice formation on the inside walls,
especially on the temperature
sensor.
Take all products and components out of the appliance and de-
frost the appliance (see the "Cleaning" chapter). Recommenda-
tion: To avoid ice formation, do not keep the freezer door open
longer than necessary. Defrost daily.
The filter is soiled.
Clean the filter (see the "Preventive maintenance" chapter).
The condenser ribs are soiled.
Clean the condenser ribs (see the "Preventive maintenance"
chapter).
None of the measures taken
correct the problem (defrosting,
cleaning of the filter and condenser
ribs).
Call technical customer service.
3
The dispenser
lanes cannot be
switched on.
No line power.
Switch on the power switch. (Start up the appliance, see the
"Daily startup" chapter).
Plug in the connector (start up the appliance, see the "Daily
procedure for starting up" chapter).
The
ON/OFF button was not
pressed long enough.
Press the
ON/OFF button for 4 seconds until the button LEDs
light up.
4
The freezer door
does not close
properly.
The hopper(s) is/are not properly
engaged in the drum hub.
Press the hopper into the appliance, turning the drum at the
handle if necessary.
5
The drum does
not turn.
The hopper is empty. The screen
displays the error message Err04
and the Action–3 [
Reset] button
flashes.
Fill the hopper with fries. Press [
Reset]. The filling process
begins.
In the hopper, fries are baked
together to form a "bridge". The
screen displays the error message
Err04 and the ACTION–3 [Reset]
button flashes.
Shake the hopper and redistribute the fries to break up the
bridge. Proceed carefully so as not to break the fries. Press
[
Reset]. The filling process begins.
6
The lifting mod-
ule does not go
up or down.
The lift motor is faulty.
Call technical customer service.
7
The basket
symbol does not
light up.
The dispenser lane is switched off.
Press the
ON/OFF button for 4 seconds until the button LEDs
light up.
The required loading size was not
reached.
See no. 12
8
The
ACTION–3
button [
Reset]
flashes.
The filling process is aborted pre-
maturely.
Press [
Reset]. The filling process begins.
In the hopper, fries are baked
together to form a "bridge". The
screen displays error message
Err04 and the ACTION–3 [Reset]
button flashes.
Shake the hopper and redistribute the fries to break up the
bridge. Proceed carefully so as not to break the fries.