G-Lab Guitar System Controller User Manual - page 10
8
In case of necessity of returning without saving settings while in the point c) should be pressed
SWITCH or MIDI button.
Indicator No.
1
2
DEF (definable) footswitch function:
loops direct switching mode entrance and exit
O
switching to the previously used bank
O
volume control: full/lowered defined by the knob
O
O
silent tuning switch on/switch off
O – indicator lit
Indicator No.
3
4
5
Indicator not lit
inactive Wah-pad
Wah-pad switches on
LOOP1
Not used
Indicator lit
active Wah-pad
Wah-pad switches on
LOOP2
Not used
SWITCH button settings
The manner of usage is identical with described above one considering only this difference that
SWITCH button should be pressed at the moment of entering and saving. In case of necessity of returning
without saving settings while in the point c) should be pressed LOOP or MIDI button.
Indicator No.
1
2
3
4
5
Indicator
not lit
MIDI program
changing
command is
always
transmitted
after pressing
preset
footswitch
Minimal time
distance
between
MIDI
program
changing
commands
is 0.1 second
Controlling
of the
second MIDI
device
disabled
“Remote” mode
of working of the
second GSC (the
same program
executed on the
second unit)
through LINK
connection
Not used
Indicator lit
MIDI program
changing
command is
transmitted only
if another than
previous one
transmitted
Minimal time
distance
between MIDI
program
changing
commands is
0.5 second
Controlling of
the second
MIDI device
enabled
“Nearby” mode of
working of the
second GSC (10
programs executed
from A, B, C banks)
through LINK
connection
Not used
MIDI channel setting
To enable receiving MIDI commands there should be set the same MIDI channel at the GSC and
at the receiving device or if the receiving device serves multichannel reception (OMNI) it should be set to
reception of any channel.
a) Memory access lock switch to LOCK position (pressed, LOCK indicator lit).
b) Press MIDI button and while LOCK indicator blinks, switch memory access lock to UNLOCK
position (LOCK indicator stops to light). All three banks’ indicators start to blink and the MIDI
indicator starts lit. Presets indicators will show the current set MIDI channel in the way described
in the below table.
c) The No. 2 preset footswitch decreases the channel No. by 1,
the No. 3 preset footswitch sets the channel No. to No. 1,
the No. 4 preset footswitch increases the channel No. by 1.
d) Pressing the MIDI button will effect in saving the channel No. (short, simultaneous blinking of
bank indicators confirm saving).