G-Lab True Bypass Wah-Pad User Manual - page 6
4
3. - Connect the guitar to the TBWP input IN (plugging in the mono Jack connector
will cause in switching on the power supply of the TBWP and the wah-wah) and
the cable from the amp to the TBWP output OUT (see the diagram from the
page No. 1).
4. - Place your foot on the wah-wah effect (the ACTIV
indicator start to lit meaning the wah-wah effect is
activated), then the wah-wah effect switch set to
active position and block it at this position by the
blocking ring being a part supplied with the TBWP
(this ring eliminates incidental switching off the wah-
wah effect while playing).
Switching on (activating) the wah-wah effect takes place in the moment of placing
your foot on the wah-wah effect and switching off – in the moment of removing your foot
from the wah-wah effect. The wah-wah pedal can be left at any position.
Switching off the wah-wah effect is performed by True Bypassing the wah-wah effect
what eliminates influence of the electronic wah-wah circuit onto the guitar tone.