Summary of Beam 300
Page 2
1.Dispacking thank you purchasing g-lites moving head beam 300. For your own safety, please read this manual before installing the device. This manual covers the important information on installation and applications. Please install and operate the fixture with following instructions. Meanwhile, ple...
Page 3
Make sure that the available voltage is not higher than stated at the end of this manual. Make sure the power cord is never crimped or damaged by sharp edges. If this would be the case, replacement of the cable must be done by an authorized dealer. Always disconnect from the mains, when the device i...
Page 4
-make sure the fixture is operated by qualified personnel who knows the fixture before using. -keep the original packages if any second shipment is needed. -don’t try to change the fixtures without any instruction by the manufacturer or the appointed repairing agencies. -it is not in warranty range ...
Page 5: 120Ω
Simply an xlr plug with a 120 Ω resistor connected between pins 2 and 3,which is then plugged into the output xlr socket of the last fixture in the chain. Please see illustrations below. 6.Lcd display operations 1. A001 display the products’ dmx address 2. 001 design the products’ dmx address cord 3...
Page 6
7.Dmx channels chanel function values description 1 pan 0-255 0～450 2 tilt 0-255 0～270 3 speed 0-255 speed of pan/tilt, from fast to slow 4 strobe 0-050 white 051-240 linear dimming 241-249 white 250-252 empty 253-255 white 5 dimmer 0-255 0-100% linear dimmer 6 color 0-014 white 015-029 color 1 030-...
Page 7
8. Technical specifications input voltage: ac100-120v 50/60hz or ac210~240v, 50/60hz lamp: philips msr gold 300/2 mini fast control signal: dmx512, master-slave and sound activated or auto operation control channel: 12 dmx channels power consumption: 400w dimensions: 396x390x630mm packing dimensions...
Page 8
270°tilt movements with 8bit/16bit resolution automatic pan/tilt reposition accidental movement not controlled by control unit 3-pin dmx connectors for input and output graphic led display with shuttle wheel aluminium structure with die-cast plastic cover two side handles for transportation pan and ...
Page 9
In order to make the lights in good condition and extend the life time, we suggest a regular cleaning to the lights. 1) clean the inside and outside lens each week to avoid the weakneness of the lights due to accumulation of dust. 2) clean the fan each week. 3) a detailed electric check by approved ...