Summary of Moving Head Beam 180
Page 2
1. Unpacking thank you for g-lites moving head beam 180. For your own safety, please read this manual before installing the device. This manual covers the important information on installation and applications. Please install and operate the fixture with following instructions. Meanwhile, please kee...
Page 3
The electric connection must carry out by qualified person. The device shall only be used with rate voltage and frequency. Make sure that the available voltage is not higher than stated at the end of this manual. Make sure the power cord is never crimped or damaged by sharp edges. If this would be t...
Page 4
-make sure to put the safety chain and check whether the screws are screwed properly when installing the fixture. -make sure the lens are in good condition. It’s recommended to replace the units if there are any damages or severe scratch. -make sure the fixture is operated by qualified personnel who...
Page 5
Be sure to complete all rigging and installation procedures before connecting the main power cord to the appropriate wall outlet. Clamp mounting: the beam provides two unique mounting bracket assemblys that integrates the bottom of the base, the included “omega bracket,” and the safety cable rigging...
Page 6
Together through serial linking. The cable needed should be two core, screened cable with xlr input and output connectors. Please refer to the diagram below. Dmx-512 connection with dmx terminator for installations where the dmx cable has to run a long distance or is in an electrically noisy environ...
Page 8
7. Photometric data.
Page 9
8.Dmx channels.
Page 12
9. Key features 2000 hour rated lamp source osram sirius hri 180w lamp (8400lumen, 7500°k, 2000h) included 59320 lux @ 2,5m 2,5° beam angle no need for adjustment of reflector or lamp anti-reflection lenses 1 color wheel with total 13 colors plus open variable direction rainbow effect with speed adj...
Page 13
Blue lcd display 14 dmx channels usitt dmx-512 (16-bit resolution) other dmx modes available customizable dmx channel assignment dmx, stand-alone, master/slave, sound activated mode dmx recorder and edit function integrated software update 3-pin or 5-pin xlr serial input/output fan cooling system co...
Page 14
10. Technical specifications input voltage: ac 100v ~ 240v 50/60hz light source: 1* osram sirius hri 180w lamp control signal: dmx512, master-slave and sound activated or auto operation control channel: 14 dmx channels power consumption: 342w dimensions: 315x359x514mm / 12.4x14.1x20.2 inches packing...
Page 15
11. Product dimensions 12. Product overviews 13. Maintenance and cleaning the following points have to be considered during the inspection: 1) all screws for installing the devices or parts of the device have to be tightly connected and must not be corroded..
Page 16
2) there must not be any deformations on the housing, color lenses, fixations and installation spots (ceiling, suspension, trussing). 3）mechanically moved parts must not show any traces of wearing and must not rotate with unbalances. 4）the electric power supply cables must not show any damage, mater...