G-lites Moving Head Beam 180 Owner's Manual - page 5
Be sure to complete all rigging and installation procedures before connecting the main power
cord to the appropriate wall outlet.
Clamp Mounting: The Beam provides two unique mounting bracket assemblys that integrates
the bottom of the base, the included “Omega Bracket,” and the safety cable rigging point in
one unit (see the illustration below). When mounting this fixture to truss be sure to secure an
appropriately rated clamp to the included omega bracket using a M10 screw fitted through the
center hole of the “omega bracket”. As an added safety measure be sure to attached at least
one properly rated safety cable to the fixture using on of the safety cable rigging point
integrated in the base assembly.
Regardless of the rigging option you choose for your BEAM, always be sure to secure your
fixture with a safety cable. The fixture provides a built-in rigging point for a safety cable on the
hanging bracket as illustrated above. Be sure to only use the designated rigging point for the
safety cable and never secure a safety cable to a carrying handle.
5. DMX-512 control connections
Connect the provided XLR cable to the female 3-pin XLR output of your controller and the other
side to the male 3-pin XLR input of the moving head. You can chain multiple moving head