G.T.Power X-Charger Operating Manual - 9. Save Data Program
-11-
8.1 Charging Pb battery
Set charge current on the left side and nominal voltage on the
right. The charge current ranges from 0.1 to 6.0A. The
voltage should be matched with the charging batteries.
Press Start /Enter for 3 seconds to start the charging
process.
The screen displays the state of charging process. Press Batt
type/Stop to stop the process. The audible beep indicates
you the end of charging process.
8.2 Discharging Pb battery
Set discharge current on the left side and nominal voltage on
the right. The discharge current ranges from 0.1 to 1.0A.
Press Start/Enter for 3 seconds to start the discharging
process.
The screen displays the state of discharging process. The
screen turns bright when press Start/Enter, then you can
press DEC/INC to change the discharge value, after this
press Start/Enter to store.
Press Start/Enter to stop discharging.
The audible beep indicates you the end of charging process.
9. Save Data Program
It has a data storage and load program for your convenience. This feature can store up to 5
different batteries data .They can be called back to the process of charging or discharging
without setting up the program again.
The screen turns bright when press Start/Enter, then you can press
to change
the value.
DEC/INC
The set parameter value in this screen just represents the
specifications of the battery, it does not affect the charge or
discharge process. The following screens will be
automatically displayed and precisely matched with the
battery type you set up. This screen shows the battery pack
of NiMH, 12cells and 3000mAh of capacity.
Set the charging current or current limits in the auto-charging
mode. Press 'INC' and 'DEC' at the same time to change
modes between 'Aut' and 'Man'
Program selection