G-Technology G-SATA Installation Manual - page 8
G-SATA Installation Guide
Page 8
5. Click on the
below will appear. Click on the
continue.
6. When the RAID is created, G-SATA will be displayed in
the left-hand panel as shown below.
7. Exit the Apple
Disk Utility
.
8. G-SATA will now be mounted on the desktop as shown
below.
G-SATA is now set up for use!!
7.2
Windows 2000/XP
G-SATA can be initialized under Windows as:
•
Two independent drive volumes (two drive letters).
•
A striped volume (RAID 0) for performance.
•
A mirrored (RAID 1) volume for data security.
The following instructions will initialize G-SATA in a striped
(RAID 0) configuration for maximum performance.
1. Power on G-SATA, wait 10 seconds, then power on your
computer.
2. When you see the message below, press
keyboard.
3. The following window will appear.