Ecombi eco1 eco2 eco3 eco4 installation manual and user guide please read these instructions carefully before installing or using this appliance for the first time..
2 installation manual and user guide 1. - warning. Please read these instructions before installing or using this appliance for the first time. The warranty of the heater will not cover any damage caused by non observance of any of these instructions. This guide must be kept and given to any new use...
3 2. - installation instructions in order to achieve a correct installation of this device, you have to follow the following steps: 1. - chose the right place to install ecombi. It is necessary that the bellow indicated minimum clearance is allowed from the appliance to any combustible material such...
4 3. - take off the front panel by removing the two screws located at the bottom. Fix the lateral fittings to the metal structure by using the appropriate screws. 4. - place ecombi in your selected installation area. Use the heater fixing holes as a template and mark the wall through the fixing hole...
5 after that please unscrew the inner panel and remove it. Warning! In the interior part of this inner panel there is a very delicate thermal insulation microtherm panel. It has to be handled with extreme care. Avoid touching it. 8. Do not disconnect the electrical heating elements. Remove the prote...
6 9. - place the storage bricks carefully, with the flat side facing the back of the heater. Arrange two row levels of bricks. 10. Place the heating elements again in their original position. Place the other two rows of storage bricks with the flat side facing the exterior and always on the heating ...
7 key “ - “ press the key to decrease different values 3. - using the appliance. Connection / disconnection. Mains switch. All models are equipped with a switch on the back side panel. It is used to connect / disconnect ecombi. Keyboard: keyboard lock: in any operation mode it is possible to lock th...
8 operation modes: pressing the key various operation modes may be selected: frost protection, automatic storage heater , emitter, ecombi manual or ecombi automatic. 1 - frost protection mode: to select this mode press the key several times until the message is displayed. The set up temperature will...
9 3 – emitter mode: this operation mode is used when it is necessary to heat the room temporarily and there is no need for storage heating. Press the key several times until the message is displayed. “Е” stands for emitter. “21.5” stands for the set up temperature in ºc. Emitter will operate until t...
10 a small red dot next to a will be displayed, when storage heater is on. Operation in this mode is similar to the ecombi manual mode but the % of the storage heater charge is corrected automatically. If working hours of emitter is higher than certain value, storage heater charge will increase in a...
11 general settings: ecombi general operation settings can be modified. By pressing the key at the same time we connect the device with the mains switch located at the right side panel, we enter to the general settings menu. This is: p1 starting time of reduced (off peak) rate electric period. P2 en...
12 6.- connection diagrams en: warning: to avoid overheating do not cover the heater. En www.Elnur.Es export@elnur.Es manufactured by elnur s.A. Pol. Ind. “el nogal” c/ villa esther, 11 28110, algete – madrid made in spain technical modifications possible without prior notice @2012 cod. 15190013 rev...
