Gabarron ECO1 Installation Manual And User's Manual - page 2
2
INSTALLATION MANUAL AND USER GUIDE
1. - WARNING. Please
read these instructions before installing or using this appliance for the first time.
The warranty of the heater will not cover any damage caused by non observance of any of these instructions.
This guide must be kept and given to any new user.
This appliance cannot be used by a non competent person.
The installation must be carried out in accordance with the current local electrical regulations. Any installation or reinstallation
has to be carried out by a fully qualified engineer.
Please check that the voltage in the rating label fits the power supply.
This appliance must be earthed.
The appliance should not be installed just below an electrical socket.
The appliance must be installed in such a way that it is impossible for anyone using a bath or shower, to touch the controls.
The use of these heaters is forbidden in any area where there is a presence of gases, explosives or inflammable objects.
If during any installation the thermal insulation shows any sign of damage, it is necessary for the faulty part to be removed and
replaced by an identical part.
DO NOT USE THIS HEATER TO DRY CLOTHES. Do not cover this heater at any time.
Air inlets and outlets provide proper operation of the appliance and prevent its overheating. DO NOT cover air inlet and
outlet grills.
Surfaces of this appliance could be hot. Children should be supervised to ensure they do not play with the heater.
This heater should be switched off at the isolating switch before any repair work is carried out. This action should also be
taken during the times of the year when heat is not required.
This appliance is only for permanent connection to a fix installation. The installation of the heaters must be carried out in
such a way that each pole can be disconnected from the supply having a contact separation of at least 3 mm.
Nominal charging time of the storage heater is indicated on the characteristics plate.
After installation a survey of the first charging cycle should be carried out to ensure that the main input thermostat switches
off. Ventilate the room during this first cycle.
Never open a charged appliance.
To maintain stability, it is essential that the heater is placed on a level surface and care should be taken to avoid irregular
surfaces, such as may result from carpets or tiled surrounds partially protruding under the heater.
The presence of air particles of smoke, dust and other pollutants could, in time, discolor the walls and surfaces around the
heater.
Incorrect time settings, erroneous programming of the reduced rate time and too high temperature settings may result in a
high cost of your electricity bill.
TECHNICAL FEATURES
Modelo
ECO1
ECO2
ECO3
ECO4
LENGTH
55cm
66cm
89cm
111cm
HEIGHT
73cm
73cm
73cm
73cm
DEPTH
18cm
16cm
16cm
16cm
WEIGHT
59kg
48kg
69kg
90kg
CONVECTOR POWER
450W
600W
900W
1200W
STORAGE HEATER POWER
525W
700W
1050W
1400W
CONNECTION
220-240V~
220-240V~
220-240V~
220-240V~
INSULATION
Clase I
Clase I
Clase I
Clase I
NUM. OF BRICKS 4,1 kg
-
8
12
16
NUM. OF BRICKS 11 kg
4
-
-
-
ACC. POWER AFTER 14 HOURS
7.35 kWh
9.8 kWh
12.6 kWh
19.6 kWh