Gage Bilt GBP744E User Manual - page 3
3
CAUTION
Keep Nose Assemblies clean and free of
chips and debris.
WARNING
Installation of fasteners may exceed
acceptable noise levels. Use approved
hearing protection.
WARNING
When operating installation equipment
always wear approved eye protection. Do
not look in front of nose assembly or rear
of tool when installing fastener.
WARNING
Be sure there is adequate clearance for
tool and operator's hands before
proceeding. Keep fingers clear of any
moving parts. Keep fingers clear from
fasteners and installed materials. Severe
personal injury may result.
CAUTION
Insure that nose assembly and tip are
properly matched for the fastener being
installed.
WARNING
Do not pull fastener unless it is placed in
an assembly, pin will eject forcibly when
pintail breaks off. Severe personal injury
may result.
CAUTION:
GAGE BILT TOOLS ARE APPROVED TO INSTALL HUCK®, AVDEL®, CHERRY®, POP®
AND OTHER FASTENERS WHEN USED BY PERSONS WITH SPECIFIC TRAINING OF
BLIND RIVET AND LOCKBOLT INSTALLATION EQUIPMENT.
WARNING
Do not operate without Stat-O-Seal (3)
and cap screw (2). Pressurized hydraulic
fluid may cause severe personal injury.
WARNING
Do not operate if deflector, bottle, catcher
bag or vacuum tube is removed or
damaged, broken pintails may eject
forcibly from rear of tool. Severe personal
injury may result.
WARNING
Always disconnect tool from power
before performing any maintenance to
any tool or nose assembly. Insure that all
connections are proper and there are no
visible leaks from tool or hoses before
connecting to power.
NOTE:
PLEASE READ THIS MANUAL BEFORE SERVICING OR USING THIS
TOOL. COMPLETE WITH WARNINGS AND CAUTIONS TO PREVENT
SEVERE PERSONAL INJURY OR DAMAGE THE TOOL.