Gaggenau AW230120 Instruction Manual - Intensive Setting

18

Intensive setting

You can use the intensive setting if there is a large build-

up of odours and fumes/vapours.

1

Press the 

#

 button.

The fan starts at speed 2.

2

Press the 

Ž

 button.

The intensive setting is activated.

Note: 

If you press the 

Ž

 button while the fan is 

running at speed 1, 2 or 3, the electronics 

automatically switch back to the previously selected 

fan speed after 6 minutes.

3

Press the 

#

 button or the button for another fan 

speed.

The intensive setting is deactivated.

Automatic mode

Switching on

1

Press the 

#

 button.

The fan starts at speed 2.

2

Press the 

 button.

The optimum fan speed 1, 2 or 3 is set automatically 

by a sensor.

Switching off

Press the 

 or 

#

 button.

Automatic mode is switched off.

The fan switches off automatically if the sensor no 

longer detects a change in the air quality of the room. 

The automatic mode lasts 4 hours at most.

Sensor control

In automatic mode, a sensor in the extractor hood 

detects the intensity of the cooking and roasting fumes. 

Depending on the setting of the sensor, the fan 

automatically switches to another fan speed.

Default sensitivity setting: 2

Lowest sensitivity setting: 1

Highest sensitivity setting: 4

Changing the sensitivity of the sensor

If the sensor control reacts too quickly or too slowly, 

change the sensitivity setting.

1

When the fan is switched off, press and hold the 

button for approx. 4 seconds.

The setting is displayed.

2

Press button 1, 2, 3 or the 

Ž

 button to change the 

sensitivity setting.

3

Press and hold the 

 button for approx. 

4 seconds.

The change is saved.

Saturation display

When the metal mesh grease filters are saturated, a 

signal sounds for approx. 4 seconds after the fan is 

switched off. The saturation indicator 

œ

 also lights up.

If you have not yet done so, the metal grease filters 

should be cleaned now.

For instructions on how to clean the metal grease filters, 

please refer to the 

Cleaning and maintenance

 section.

Resetting the saturation indicator

Press and hold the 

œ

 button until the saturation 

indicator is no longer lit.

The saturation indicator is reset.

Button 1

= Sensitivity 1

Button 2

= Sensitivity 2

Button 3

= Sensitivity 3

Ž

 button = Sensitivity 4