1. DL manuals
  2. Gainsborough
  3. Door locks
  4. G+ LOCKSET
  5. Installation Instructions Manual

Gainsborough G+ LOCKSET Installation Instructions Manual

Summary of G+ LOCKSET

  • Page 1

    Note: • carefully follow these instructions when installing as the process differs from other gainsborough products. • do not overtighten screws. • use of power driver is not recommended. • screws to be tightened to a recommended 2.5nm torque. • fully remove the g+ lockset prior to painting the door...

  • Page 2

    Task 1 • hold faceplate up to the door making sure that the correct faceplate is used. I.E. Outside faceplate to outside door face. (the outside faceplate is the one with the sliding cover). Turn the lever in the required direction until it “clicks” into place. Do this for both the outside and insid...

  • Page 3

    Task 1 • mark and chisel a recess of 4mm for the power transfer unit faceplate. (so that the power transfer unit faceplate is flush with frame edge face). Use the power transfer unit as a template. • mark and chisel a recess of 1.5mm for the strike. (so that the strike is flush with frame edge face)...

  • Page 4

    9 8 a b c d 7 • fold template where indicated (make sure the correct template is used). • position template on door edge with the template on the inside door face . Close the door while holding template to door face. Line up the latch centreline on the template with the middle of the strike on the d...

  • Page 5

    Task 2 • refer to g+ lockset user guide before changing these switches. • if there is more than 1 g+ lockset in the house, switch a might need to be changed. • insert 4 rechargeable nimh aaa batteries making sure correct polarity (+ and -) orientation. • assemble the battery box transmitter and fix ...

  • Page 6

    Task 3 13 14 15 • insert key and turn clockwise. • remove the mounting plate. • the key can now be turned back to the vertical position and removed. • the rotor is pre-installed onto the mounting plate. The rotor must be positioned such that one notch faces upwards, and the other notch faces towards...

  • Page 7

    Task 4 16 17 • installing the batteries into the g+ keys. • remove the battery compartment cover by twisting anti-clockwise and lifting off. • insert two batteries + side up (as per diagram above). • replace the battery compartment cover and twist clockwise to lock. • perform the following steps to ...

  • Page 8

    This document contains general information only and is in no way to be regarded as a complete and comprehensive guide. Gainsborough hardware industries limited acn 004 792 269 (gainsborough hardware) makes no representation about the content and suitability of this information for any purpose. You s...