Gainsborough G+ LOCKSET Installation Instructions Manual - page 2
Task 1
•
Hold faceplate up to the door
making sure that the correct
faceplate is used. i.e. outside faceplate to outside door face.
(The outside faceplate is the one with the sliding cover).
Turn the lever in the required direction until it “clicks” into
place. Do this for both the outside and inside faceplates.
• If rehanding is required, insert a flat blade screwdriver under
handing plate and twist. Rotate lever towards top of the
faceplate and remove screwdriver. Continue to rotate lever
for 180° until it “clicks” into place.
• Position and hold the
inside G+ Lockset
onto the
door
face
to determine the most suitable height of the lock
(this height will vary depending on the door style).
• Carefully make a
mark
on the door frame at the same
height as the
door lever.
• Remove the G+ Lockset.
•
Position the template
supplied (see packaging) on the
door frame so that the
lever height centreline
aligns with
the
lever height mark
you made in the previous step.
• Firmly hold the
template
and
mark the 2 Power Transfer
Unit heights
(top markings) and the
2 Strike heights
(bottom markings) on the frame.
• Remove the template and measure the
door thickness.
Divide this size in half and measure this size from the jam.
(Take note of any weather strips that may be fitted to the
door jam). Mark this position on the
2 Power Transfer Unit
markings
and the
2 Strike markings.
(Diagram 3)
• Drill the 2 top holes diameter 1 inch through the frame.
• Drill the 2 bottom holes diameter 1 inch by 20mm deep
(or through if the frame thickness is near this size).
• Chisel wood to join the 2 top holes (power transfer
unit holes).
• Chisel wood to join the 2 bottom holes (strike holes).
NOTE: If the Door Frame has previously been prepared, then
go straight to Step 4. (i.e. if there are 2 holes in the door frame)
NOTE: The door furniture faceplate levers are supplied in a
neutral position. These need to be “handed” before installation.
Door lever height mark
1
2
3
Lever height
marking
Strike heights
Power transfer
unit heights
1/2 door thickness
1/2 door thickness