Galanz AUF-48H58R520 Owner's manual - page 9
8
OPERATION OF AIR CONDITIONER
Operation procedure-Control under the Remote controller
Press FAN SPEED button, change the fan speed of indoor unit in the order of :
Sleep selection
Press SLEEP button, set sleep operation, and cancel when repressed.
Run/Stop
Press I/O button, start operation, and stop when repressed.
Temperature adjustment
Temperature change will display on the remote controller display, and temperature indicator
will display room temperature and setting temperature too.
Air flow speed adjustment
(Note: because the quasi-intelligent design of the machines, the conditioners may
not follow the air flow speed set by the controller during operation. This is normal
because the machine is controlled by the conditioner's fuzzy control system.)
Swing selection
1
2
3
4
5
6
7
8
Press ELECTRIC HEATING button, electric heater operation, and cancel when repressed.
ELECTRIC HEATING selection
(only applied to electric-heat series)
OPERATION MODE adjustment
COOL DRY
Press OPERATION MODE button, the operation mode change in the order of:
Timer operation
Cooling only type:
Heat pump type:
COOL DRY HEAT
AUTO-ON/OFF timer operation set
AUTO-ON/OFF timer operation cancellation
1) When the unit is on press the timer button once to start timer off function and 1 will be shown on
the display , every press of this button increases the AUTO-OFF time by 1hour(24hours at most),
after it accumulates to 24 the air conditioner will quit timer function .
When the time of timer reach 24, press timer button again the timer function will be cancelled,
then the time and hours on or hours off disappear on the remote controller display.
Press SWING button, the deflector starts swing, and press MANUAL SWING button to stop it.
( low )
( high )
( low )
。
Press TEMPERATURE ADJUSTMENT button,
decreases 1 C by pressing
。
button once, and increase 1
C
by pressing button once.
the set temperature
“
“
”
”
2) When the unit is off , press the timer button once to start timer on function and 1 will be shown on
the display , every press of this button increases the AUTO-ON time by 1 hour (24hours at most),
after it accumulates to 24 the air conditioner will quit timer function . When the timer on is activated
the relative indicator lamps will light and modes can only be changed by pressing the buttons on
the remote controller.