Galaxy Audio Any Spot Traveler AS-TV8 User Manual - page 17

Operation of TV5 and Optional Modules (See Page 14) 

1.      For AC power operation or Charging: Connect the DC end of the 

Power Supply/Charger cable to the DC In Jack (

I1). Then connect the 

other end (AC plug) to the AC wall outlet. 

2.      See page 2 for more information on Charging, Power Switch, and LED 

Indicators.

3.      The Aux Out Jack (

I5) provides a Pre-Master, Pre-Tone line level 

output of the entire mix.

4.      The Aux In Jack (

I6) is a line level input and is controlled by the Aux 

Volume (

I9).

5.      The ¼" Mic Input (

I7) will accept balanced or unbalanced, high or low 

impedance mic signals, and is controlled by the Mic Volume (

I8).

6.      Turn the Tone control (

I10) to the left for more bass and to the right for 

more treble. This affects the entire mix of inputs, but not the Aux Out 

signal.

7.      The Master Volume (

I11) controls the overall volume of the entire mix, 

but has no effect on the Aux Out signal.

J. AS-DIGIMP5 Optional Media Player. (See page 14) 

1.      The AS-DIGIMP5 will play audio in the MP3 format from either SD 

Cards or USB Devices. Press (J1) to switch on the power. The LCD 

(J2) will display “C” when an SD card is inserted into the slot (J8), or 

display the “USB symbol” when a USB device is plugged into the USB 

Jack (J10). Track number, time counter, and play/pause status will also 

be displayed. To switch from one format to the other, simply unplug 

one media device and plug in the other. 

2.      Normal track play functions are controlled by buttons (J3) thru (J7). 

The Repeat button (J5) offers three modes: Off, repeat track, and 

repeat all tracks.

3.      (J11) controls the volume. The Pitch (speed) of playback may be 

altered up or down using (J9). For normal Pitch set the control to the 

center detent. 

For a Description and Operation of the Optional Wireless Microphone 

Receiver (TVREC) (see pages 9 and 12).

Notice: 

Changes or modifications not expressly approved by the party responsible 

               for compliance could void the user's authority to operate the equipment.

IMPORTANT NOTE: To comply with the FCC RF exposure compliance 

requirements, no change to the antenna or the device is permitted. Any change 

to the antenna or the device could result in the device exceeding the RF 

exposure requirements and void the  user's authority to operate the device.

This device complies with Part 15 of the FCC Rules. Operation is subject to the 

following two conditions: (1) this device may not cause harmful interference, and 

(2) this device must accept any interference received, including interference that 

may cause undesired operation.