Galaxy Audio HOT SPOT User Manual - Page 10
Page 10
USING THE HOT SPOT WITH THE PA5X140
POWERED MONITOR
The PA5X140's SPEAKER OUTPUT jack is designed to allow a
maximum of two HOT SPOTS to be “daisy-chained” to it.
The PA5X140 produces 146 watts when powering two HOT
SPOTS (see figure below)
Route cables:
1) From the microphone to Galaxy Audio’s PA5X140.
2) From the output of the PA5X140 to the first HOT SPOT.
3) From the first HOT SPOT to the second HOT SPOT.
1 2 3
STAND MOUNTING
All HOT SPOT's, both powered and un-powered, have a built in
microphone stand mount: just slide the microphone stand into the
receptacle on the bottom of the HOT SPOT. Some microphone
stands may require an adaptor (contact any Galaxy Audio dealer
and ask for an SA-1, microphone stand adaptor).
Permanent piece and the collar will
not allow HOT SPOT to sit deep enough
Stands that need SA-1’s
K&M™ series stands
AKG™
Beyer™
Sennheiser™
Ultimate™
No SA-
1
needed
stands
allow HOT SPOT to sit
deep enough on the stand
Atlas and SHURE
Stands that don’t
need SA-1’s
Atlas™
SHURE™
THE SA-1 WILL ALLOW YOU TO SECURELY PLACE
YOUR HOT SPOT ON ANY MICROPHONE STAND.
SA-
1
needed
SA-
1