Gallet ASP 120 Vernon Instruction Manual - IV. Use of Vacuum Cleaner
EN
EN - 33
III. VACUUM CLEANER PREPARATION
Hose (Fig. 4)
– Connect hose
C2 to the vacuum cleaner by inserting the end piece to suction vent A1
to the maximum position and turn to the right (Fig. 4). You will hear a clicking sound.
– To disassemble proceed in the reverse sequence.
Telescopic tube (Fig. 3)
– You can connect tube
C3 with hose handle C2 by slight pushing the handle to the tube.
– You can disconnect the tube by pulling the handle slightly out of the tube.
– The telescopic tube allows setting suitable length to fit your figure. Press the lock pin in
the direction of the arrow and pull out or push in the required length of the tube. When
you release the lock projection, the tube length is fixed. When pulling out, keep the tube
in safe distance from your face as the tube is very long.
Floor nozzle (Fig. 2)
– Connect and disconnect the accessories (
C1) in the same way as the tube.
Floor / crevice nozzle / brush (Fig. 3)
– Connect and disconnect the accessories (
C4, C5, C6) in the same way as the tube.
You can connect the appliance directly to the hose handle or to the telescopic tube.
IV. USE OF VACUUM CLEANER
Remove all packing material, take out the vacuum cleaner and the accessories. Pull out
necessary length of power cord
A5 and plug the power cord into a socket. Assemble the
vacuum cleaner accessories
C1, C2, C3 (Fig. 2, 3, 4). If the cleaner is fitted with telescopic
tube
C3, adjust its length to fit your figure (Fig. 3). Floor nozzle C1 is designed to be used
to clean carpets or smooth flooring (Fig. 5). If the floor nozzle is fitted with a brush, pull it
out by switching over a flap when vacuuming hard floorings. You can use crevice nozzle
C6 for vacuuming places that are hard to access (Fig. 6). Upholstery nozzle C4 or brush
C5 can be used to clean various types of furniture (Fig. 7, 8). The vacuum cleaner can be
switched on or off by pushing button
A4 marked with the symbol (Fig. 9). The suction
power can be adjusted with the control on hose handle
C2 (Fig. 10). The minimum suction
power is recommended for fine fabrics (e.g. curtains, drapes). The maximum suction power
is recommended for floor coverings (e.g. heavy-duty carpets). After finishing work, switch
off the vacuum cleaner and unplug it from the power supply. By switching button
A3 with
symbol
(Fig. 9) the power cord will be wound automatically. The vacuum cleaner can
be held and carried by handle
A7.
Emptying the dust container
When vacuuming, watch the level of filling of the container with dust. When you notice the
container is full or you feel significant decrease in the suction power, empty the container.
Press container lock buttons
A6 and then remove container B from the vacuum cleaner (Fig.
12A). Put the container above a dust bit and press button
B1; thus you will lift off bottom B2
and throw the dust in common municipal waste (Fig. 11). Snap the bottom shut to secure
it and insert the container into the vacuum cleaner in the opposite direction. For sanitary
reasons we recommend emptying the container outside housing premises.