Gallet VEN41S Blizzard Instruction Manual - page 15
EN - 15
EN
DEscrIPTION Of THE cONTrOLs
P1 Front grill
P2 Blade
P3 Rear grill
P4 Motor cover
P5 Oscillating knob
P6 Motor
P7 Screw B
P8 Extension pole
P9 Height adjustment nut
P10 Base cover
P11 Base tube
P12 Screw A
P13 Shaft
P14 Piano keys
P15 Grill screw
P16 Blade screw
P17 Clip
P18 Swivel adjustment knob
P19 Vane
P20 Base
INsTrUcTIONs fOr UsE
Assembling of unit
Take all parts out of the box and remove all packing material.
1) Fasten the base tube P11 on the cross base P20 with screw A (P12)
2) Slide the base cover onto cross base along the lower pipe.
3) Pull the extension pole (P8) out and the tighten the out-joint.
4) Place the motor and switch box firmly on the top of the extension pole, and tighten screw
B (P7)
5) Unscrew the gril screw P15 from motor cover P4 and put the rear grill P3 on the motor cover
P4. After this tighten the rear grill by screw P15.
6) Place the blade P2 and tighten by blade screw P16.
7) Fasten the vane P19 on the front grill P1 by swivel adjustment knob P18.
8) Put the front grill P1 on the rear grill P3 and tighten with clip P17.
9) This all part put in to the base tube P11, set requied height and tighten nut P9.