Game Ready 550550 User Manual - page 9
4
5
You can choose to operate in either Manual Mode or Program Mode.
Manual Mode allows you to adjust time and pressure settings.
Program Mode allows you to choose one of six programs that provide
treatment for a set time then sleep (no treatment) for a set time,
continuously, at a specific pressure setting. The unit will default to
Manual Mode.
SteP 12:
Press play/pause button.
U S i n G Y o U r G A M e r e A d Y S Y S t e M
SteP 7:
Apply the selected Wrap (consult the Use Guide for each Wrap for application
instructions).
Warning:
Do not place directly against open wounds, sores, rashes,
infections, or stitches. May be applied over clothing or dressing.
Caution:
If applying the same Wrap to another person, make sure the
Wrap is deflated before the next application.
SteP 8:
Connect the smaller end of the Connector Hose to the Wrap. Make sure
you hear it click. To disconnect, simply press the button and remove the
connector from its port.
If you have any problems with the set-up of your Game Ready System, please contact
Game Ready Customer Service at .888.426.3732.
Warnings:
• Follow the recommendations of your health care practitioner.
• Improper placement or prolonged use of Game Ready could result in tissue
damage such as frostbite.
•
For additional warnings and precautions, please refer to pages 5-6 of this manual.
SteP 9:
Press the power button. The screen should light up and the
Control Unit should beep once. The power indicator light
should turn from orange to green.
SteP 10:
Adjust the temperature by turning the temperature knob. Turning
the knob right, toward 3 snowflakes, will provide more cold therapy.
Turning the knob left, toward 1 snowflake, will provide less cold
therapy.
U S i n G Y o U r G A M e r e A d Y S Y S t e M
Click
Disconnect Button
Click
Manual Mode:
Set the time by pushing the +/- buttons.
Set the pressure by pushing the pressure button. You can select
from 4 pressure settings: No pressure, Low Pressure (5-5 mmHg),
Medium Pressure (5-50 mmHg), High Pressure (5-75 mmHg).
Program Mode:
Push the program button to enter Program Mode. In Program
Mode, the unit will operate continuously according to the selected
program. You will need to add ice approximately every 3-4 hours.
You can select from the following programs:
Program 1:
30 minutes on, 30 minutes sleep. No pressure.
Program 2:
30 minutes on, 30 minutes sleep. Low pressure.
Program 3:
30 minutes on, 30 minutes sleep. Medium pressure.
Program 4:
30 minutes on, 60 minutes sleep. No pressure.
Program 5:
30 minutes on, 60 minutes sleep. Low pressure.
Program 6:
30 minutes on, 60 minutes sleep. Medium pressure.
Program d:
Drain Mode. Please refer to page 9 in this manual
for details.
SteP 11: