Gamma 6500 Els Owner's Manual - page 10
Instructions for Power Connection (Refer to Figure 1)
CAUTION ! Before connecting to the power supply, check the voltage supply switch
setting located on the side panel as shown in Figure 1. To change from 115 volts service
to 230 volt service simply slide the switch fully to the top or to the bottom until “115V” or
“230V” appears on the switch plate.
The acceptable range of input voltages for the “115 V” setting is between 110 V and 120
V @ 60 Hz and for the “230 V” setting, between 220 V and 240 V @ 50 to 60 Hz. If you
have any question regarding the input voltage supply for your area, please ask your
electric utility company.
To install the power cord, insert the female end of the power cord into the Power Cord
Socket located on the side panel and plug the male end into a grounded power outlet.
When using extension cords, use grounded heavy duty extension cords rated for 15
AMP service. To connect the foot pedal switch, insert the 2 pin male connector located at
the end of the foot pedal switch cord into the two pin receptacle located on the back
panel. Tighten the connector with the sleeve nut located on the foot pedal switch
connector.
After checking to be certain that the machine is set for the correct input voltage, switch
on the machine by pressing the Lighted On-Off Power Switch on the side panel.
WARNING!
FOR INDOOR USE ONLY. TO BE USED BY ADULTS OR
UNDER ADULT SUPERVISION ONLY. NEVER OPEN UNIT WITH
POWER CONNECTED
POWER CONNECTION AND CONTROLS
9
“E”
“H”
Figure 3 - Back Panel
“J”
Figure 1
“A” - Lighted On-Off Power Switch
“B” - Sliding Fuse Holder w/ Spare Fuse
“C” - Tension Adjustment Knob
“D” - Power Cord Socket
“E” - 115V / 230V Switch
Figure 2
“F” - Split Drum String Gripper
“G” - Tensioning Button
“H” - Control Panel
“I” - LED Display
Figure 3
“J” - 2 Pin Foot Pedal Switch Socket
Figure 1 - Side Panel
Figure 2 - Front Panel
“A”
“B”
“C”
“D”
“F”
“G”
“I”